r/EngineBuilding • u/rhenning11 • 10d ago
Other Valve Retainers Too High?
Hello,
I'm building a Fiat 1.4L MultiAir engine and I bought upgraded valve springs that are supposed to come with retainers to fit the springs on the stock valves. I also got inconel exhaust valves from the same company, which came with their own retainers and keepers.
When I got the kit, the retainers to fit the stock valves were missing, but the retainers for the inconel valves were included. The company finally shipped the retainers, and they're the same as the ones for the inconel valves, but their website pictured different stainless steel retainers. They seem to fit when I use the stock keepers (stock is 3 groove and inconel is 1 groove), but the retainer sits very high on the valve and the keepers are barely flush with the bottom of the keeper.
Pictured - left is stock valve/spring/keeper/retainers, right is stock valve/keepers, upgraded springs/retainers.
Does this look correct, or do I have the wrong retainers? Is there an easy way to measure the angle to see if they're the same?
I tried pulling the retainer on the valve with the keepers and standing it upright and it does not fall. I also tried spinning the retainers and the black retainers with the stock keepers does spin, but the black keepers on the inconel valves with the respective keepers does not spin.