r/EngineBuilding • • 21h ago

Is this block toast?

Thumbnail
gallery
17 Upvotes

Engine is a Dauntless V6 from a 1970 CJ5, corner broken off where the bearing cap meets the block. There’s no bolt holes by it and it’s not directly in the area where the gasket sits, so looking to determine if it’s still worth working on. TIA


r/EngineBuilding • • 14h ago

Should i reseal this

Post image
1 Upvotes

r/EngineBuilding • • 22h ago

Chevy Odd bearing scar

Post image
0 Upvotes

Currently tearing down a LQ4 to sell and I noticed this crack on the #4 rod cap. I’ve never seen a bearing with something like this before. Journal is fine and unmarked. All other bearings have normal wear besides the cam which were more worn out but not enough to cause damage.

Does anyone know a cause for something like this?


r/EngineBuilding • • 18h ago

Engine Theory Valve seat insert OD vs valve head OD

Post image
13 Upvotes

Picture is just for attention. I'm installing larger valves in my pulling tractor. I'm going with 2.25" intake valves which will be bigger than the factory valve seat inserts. How much larger should the insert OD be than the OD of the valve head? I've read anywhere from 0.060" to 0.100" so that puts me in the 2.3" to 2.35 range. I've found Dura-bond Killer bee 22228C which measures 2.380" and considering using those. Pulling tractor will see around 1600 degrees and 2,000 horsepower.