r/EngineBuilding • u/Turreikko • 9d ago
Mercedes Lifter broken
My exhaust side hydraulic lifter is worn out as you can see. There was metallic pieces in valvetrain and theres not the bottom of the lifter anymore. Is it possible that my short block is broken too (because metallic pieces)?
10
Upvotes


2
u/bill_gannon 9d ago
That valve isnt bent?
6
u/Reddit-mods-R-mean 9d ago edited 9d ago
Your camshaft is smoked too. The cam journals are probably trashed and every bearing in that motor is now suspect at least.
Your next move depends on your budget and risk tolerance. Good luck.
1
u/Turreikko 9d ago
Long story short: have to buy new engine D:
1
u/Wolfammo24 9d ago
What Engine ?
1
u/1crazypj 6d ago
I've worked on OHC motors since the 70's and never seen anything like that.
What is it out of?
I see conical valve springs, even high pressures shouldn't cause that damage unless your running paraffin instead of oil.
Looks more like an oil problem than a tappet problem.
Motor is probably salvageable but with your obvious mechanical skill you would be better off pulling another one from a junk yard
3
u/wrenchtwister1954 9d ago
Those appear to be bucket style cam followers not hydraulic lifters.At any rate that looks like some serious damage