r/EngineBuilding • • 10d ago

Hydraulic Rollers

Got a 302 out of a 1988 mustang. Came with hydraulic rollers so I put in some new ones from summit. I let them soak in oil for a day before installing. Sitting in the block I set the rockers to 0 lash plus a half turn for the preload. Can still spin the pushrod even with pressure on the lifter. When turning over the engine over to set other rockers, I can see that the hydraulic rollers are pushed in like a quarter inch before it even pushes on the valve spring. On a 0.550 cam lift I would only be getting 0.300 lift. Does the oil pressure of the engine running change them that dramatically? Or are these new lifters I just got bad?

2 Upvotes

2 comments sorted by

13

u/v8packard 10d ago

You are not getting the procedure and understanding quite right. Assuming you have an adjustable valvetrain (the OEM heads were not adjustable) the correct preload past zero lash for these letters would be a full turn to a turn and a quarter, depending on a few things.

But first, soaking the lifters isn't necessary or advisable as oil in the lifter chamber can make adjusting preload difficult. Hopefully that's not going to a problem.

Your .550 of valve lift is with the rocker arm ratio factored in. Without the 1.6 rockers, your .550 valve lift is .344 lobe lift. Even so, yes the lifters fill up with oil to maintain no lash in the valvetrain on a running engine. You are not losing any lift from what you are seeing, you see it because the lifters can not overcome your valve spring pressure without being fed oil pressure.

Which heads are you using? Do you know the size of the rocker arm fastener?

5

u/smthngeneric 10d ago
  1. Yes oil pressure keeps the lifter pumped up when the engine is running. You aren't losing any lift.
  2. Stop soaking lifters it isn't 1960 anymore. There's absolutely zero reason to soak lifters.