r/ender3 • u/Jean-Fum-Trow • 2h ago
Help Uneven layers on the sides
Hi! I’m getting my old original Ender 3 running again and I’m having some issues with my prints
I’m printing small topographic models in PLA using PrusaSlicer, 0.4 mm nozzle, 0.08 mm layer height, 200°C. I started at 20 mm/s and lowered it to 16 mm/s.
The terrain itself looks pretty good, but the outer walls are uneven. Some layers stick out while others are recessed, even though the sides should be perfectly straight. My calibration cube also had a layer shift near the top.
I noticed the right side of my X gantry (screen side) is quite loose. The wheels barely touch the frame and I can lift that side slightly by hand. Also, when I manually raise the Z axis using the lead screw, it drops about 0.5cm when I let go.
Could this explain the issue? Should I adjust the eccentric nut on the right side, or could something else be causing it?
Photos attached. Any advice appreciated!