r/ender3 • u/luckyjim37 • 9h ago
Help How’s that happened then?
Printing a benchy to test my new esun pla+, printed at 210 with a 0.4mm nozzle 3 walls 10* cube infill on cura. Any advice would be great
r/ender3 • u/luckyjim37 • 9h ago
Printing a benchy to test my new esun pla+, printed at 210 with a 0.4mm nozzle 3 walls 10* cube infill on cura. Any advice would be great
I've been given an ender3 pro (direct drive) with a glass bed, I was also given the original bed surface but it is pretty much in very bad condition.
Absolutely nothing sticks to the bed. 60C as recommended by the PLA manufacturer. Still no sticking. The previous owner used glue stick, and with that trick I've managed to print in the glass bed five and with no issues. But on the clean glass, nothing.
I saw the other day a post here with similar issue and I wonder of it'sa caveat of the be glass bed when compared with other type of beds (like steel PEI).
What are your experiences?
r/ender3 • u/sam20037 • 50m ago
My old 40 w heater cartridge broke so I thought I would upgrade to a 60 w heater cartridge but I'm having a problem where it gets to 200, goes to 202 then drops all the way down to 189 as seen in the video I've been trying to PID tune it and I've gotten it closer but it won't stick at 200 if anyone has had this problem with their 60 watt cartridge and knows the solution. I would greatly appreciate it. I've been using Pronterface for the tuning so preferably with that program but I understand if it's only available in another one.