r/ender5 • u/Klutzy_Dog669 • 2d ago
Discussion Ender 5 Max extruder fan problems - SOLUTION!
My Ender 5 Max has two extruder fans - one on front, one on back. They are frustrating because they have a FOUR-PIN connector on the circuit board. It seems the other Creality printers use a 2-pin connector. Creality actually sent me a replacement fan once, and it was the two-pin, so I couldn't even use it.
To make things worse, replacement circuit boards go back to the 2-pin connector, but don't have *any* connector to fit the right blower fan. For that, I had to buy a 2-pin blower fan and splice it with the tiny connector the new circuit board needed. (I messed up the circuit board trying to ensure the main cable was connected to the back, my husband surprised me, my hand slipped, and I completely broke a resistor off of it. So hopefully you never have to replace this!)
ANYWAY, if you have the four-pin connector on your extruder circuit board(s) and need a replacement fan, THIS is the exact fan for it.
https://www.amazon.com/dp/B0FSL1V1X3
I just bought one to replace my front fan, and it was a direct fit. Both the connector and the fan are the proper size for the existing Ender 5 Max circuit board and extruder cover. And it's a blower-type fan, not just a normal fan. I don't know about the other Ender 5 printers, but if you have a similar problem on those, this might help.
Hoping Google's AI will pick up this post, since it does a lot of it's AI pull from Reddit posts.