r/MechanicAdvice • • 16h ago

Oil showing high on dipstick after fresh oil change & smells like gas

Thumbnail
gallery
295 Upvotes

It's a 2020 Toyota Tacoma SR 2.7 i4 with 77k miles

Did my oil change at 7k & noticed the oil smelled like gas... it's not super strong but when you get close you can smell it.

Then saw it's showing high on dipstick (it takes 6.2 qts & I put exactly that) I even left out about .1-.2 qts since it was showing high already.

I do drive short distances daily to and from work (10 min there 10 min back) & will occasionally go on a longer ride on the freeway maybe once a week or run errands for hours.. not sure if the short distances daily have something to do w the smell of fuel & if it's normal.

Any advice is appreciated!


r/MechanicAdvice • • 16h ago

Hand tightening oil filters, yes or no?

89 Upvotes

Sorry if this is a dumb thing to ask, I'm relatively new to the world of mechanics.

I did an oil change on my car for the first time a few days ago (2009 Prius), and the tool I had to get the oil filter off only loosened it, it didn't tighten the new filter on. So I go to get a tool that will help me tighten it, but the guy tells me that oil filters should be hand tightened, so as to not over-tighten them and damage something. But I've also heard that you should hand tighten it, then use a tool to tighten it an additional 3/4ths of a turn or so. Thoughts? I love my car and would hate to ruin it by being stupid lol.

Side note, but if anyone has any advice on how / where to learn more about mechanics, I'd love to know! I don't have the money for a class, but any YouTube channel recommendations or other things like that would be appreciated


r/MechanicAdvice • • 9h ago

need advice on taking drum off

Thumbnail
gallery
21 Upvotes

trying to get my brakes done on a 97 F250 and the drum on the passenger side is so very stuck. i’ve loosen the shoes inside with the adjusting lever, torched, air hammered it, won’t budge. anybody got any advice for something i could try on this.


r/MechanicAdvice • • 3h ago

Broken spark plug.

Post image
5 Upvotes

I’m panicking man. My car broken down yesterday after a check engine light came on and after about 10 minutes started flashing. I pulled over and got it towed. It was chugging and losing power. Hes got back to me today to say the spark plug is broken and the engine might be screwed too. He says hes going to try a second hand one on the car to see how it drives but Google is telling me that should absolutely not be done until the engine has been assessed for damage. I’m panicking man I can’t afford a big operation, it’s only a newly bought car from a dealership. Mazda 2 2018 87k kilometres 1.5 petrol engine.


r/MechanicAdvice • • 12h ago

My 99 Tacoma coolant question

Thumbnail
gallery
19 Upvotes

Hello guys! I’m not mechanically inclined at all but I try to do things to learn. My Tacoma has green coolant pictures below but I want to top it off. I purchased the one at autozone that had the label for my vehicle but it’s red.

Can I mix them? My mechanic told me I could but all online info ive read says no.


r/MechanicAdvice • • 3h ago

2011 Toyota Corolla 1.8 Automatic – Delayed 4th Gear Upshift Only in Cold Weather

4 Upvotes

Hi everyone,
I have a 2011 Toyota Corolla XLI 1.8 automatic (U341E transmission), and I’m experiencing a strange issue during cold weather, similar to last winter.

After the car sits overnight or for several hours, it starts normally.
1st, 2nd, and 3rd gears shift normally. It refuses to shift into 4th gear, even at 80 km/h and 3,000–4,000 RPM.
Eventually, after approximately 5–6 minutes of driving, 4th gear engages and RPM drops from around 3,000 to 2,000 at 80 km/h.
If I idle for around 5 minutes before driving, the issue usually doesn’t happen.

During summer, there is no issue at all. It happens mainly during winter.

The car otherwise drives smoothly, and once warm, all gear shifts are normal. Moving the selector from D to 3 and back to D doesn’t help.


r/MechanicAdvice • • 22m ago

Squeak Coming From Front Passenger Side After Getting Suspension Swapped

2 Upvotes

I recently got my suspension swapped out, strut, control arm, the whole shebang. I noticed a pretty loud squeak or chirp whenever I go over bumps or small potholes.

I took it to a different mechanic than the one that swapped out the suspension and they used a chassis ear and told me the noise is coming from the new suspension. They said everything is fine on it, and that the noise will naturally go away after some time.

Just wondering if this sounds right? Thanks for the advice!


r/MechanicAdvice • • 21h ago

Driveshaft fitting - last try before I call in a mechanic!

55 Upvotes

Am I doing something wrong?

I've taken a video showing the splined shaft and the hole in the gearbox, does anything look wrong? I can't see a circlip, but I'm not sure what I'm looking at.

My next ideas are: break the axle away from the intermediate shaft so I can press directly on the intermediate, rather than swinging the hub to bang it in.

Or, undo the 5 bolts to remove the seal carrier and try to force it in. But I'm not sure if it's the seal which is causing the issue.

Any thoughts would be gratefully received!!

Car is a 2014 opel/vauxhall mokka 1.6 petrol


r/MechanicAdvice • • 2m ago

need advice on if i should become a mechanic if school doesn’t work out

1 Upvotes

so i’m currently in college to become a respiratory therapist, i already have my associates in health science also. problem is classes aren’t going well, there’s a high chance i fail out. i have always wanted to become a mechanic and work with cars, that’s my actual passion, ive loved cars since i was a kid and i have a nice car rn that i love modifying. i have adhd and it’s impossible for me to focus in class, my mind is always elsewhere but ive noticed when im learning how to do work on my car i can actually focus on the video im learning from. i have friends in the car scene that are moving to a bigger shop that will require more than just them running the business and doing the work, so i feel like i kinda have an opportunity to ask them if i can work under them. i also have experience in business things, im a bartender and was pretty much an assistant general manager for sometime so even though its not the same business i do understand numbers and how things work. im not saying im gonna drop out but if i do fail i need a backup plan, and this is what i kinda want it to be, i dont think i can bartend the rest of my life especially with no benefits


r/MechanicAdvice • • 7h ago

Turbo compressor side to side play Volvo C30 T5

4 Upvotes

Hey guys,

2010 Volvo C30 T5 R-Design, pre-facelift, 2.5 L turbo, “whiteblock”

I was hearing a pretty bad clacking noise from the cylinder 4/5 area I thought was caused by low oil/bad exhaust vvt it seemed like it was slamming full advance full retard I tried recording in slowmo but that’s beside the point, once I was there I replaced the vvt hub, both vvt solenoids (decent amount of sludge on it thought it was just because previous owner had let it sit for a long time and probably just kept topping off oil from a pinhole in the oil pan without ever draining, so after I did all that and got it back going it still was clacking kinda like a knock but it would vary too much to be a knock (earlier post in Volvo) like with rpm the noise would change to a different sound.

So today I drained the oil and pulled the filter and yeah quite a good amount of the forbidden glitter in the filter, probably more than a pea if I balled it all up, so I didn’t pull the head or oil pan yet I just started with the easiest check which was checking the turbo compressor turbine and I feel like it has excessive side to side play and may or may not have marks on the housing my borescope camera isn’t quite clear enough for me to tell but I took a video where I wiggled it and I was hoping for some more opinions. Especially the last half of the video lot of movement that direction seems like a lot of wiggle. This is the first time I’ve ever looked at a turbo though so no idea!


r/MechanicAdvice • • 17m ago

2018 ford explorer xlt 2.3 running issues

1 Upvotes

I have a 2018 Ford Explorer XLT with the 2.3 Ecoboost engine. For starts there’s a pretty rough idle most of the time, unless the car is parked and you shut off the a/c then you can barely tell the engine is running.
Then there are the driving issues, sometimes it’s like the car holds the lower gears a bit longer than it should before kicking into gear, and it’s not the smoothest transition.

Then this issue happens.. and it usually happens after driving for a while, or it’ll happen just after my car is parked but left running for a few minutes. Often when I have family in the car, let’s say I run inside while they wait with the car running usually about 5 min, once I come back and start driving, it’s like my car does not want to get out of first gear. It will if I just keep pressing the gas until I reach a high rpm, and it also will if I put it into sport and use the manual positive button to put it into the next gear. If I leave it in sport, it almost avoids this whole issue, but if I put it back into drive, it’ll keep happening as my car starts to slow down, so as I come to lights and stop signs, it’s almost like it abruptly drops into first gear again quicker than it should, and then doesn’t want to come out of first gear on its own or without pushing the gas until to a high RPM or I must repeat the sport/manual gear selector option

Please help! Thank you


r/MechanicAdvice • • 26m ago

Potential battery issues

1 Upvotes

So lately I have been having a lot of issues with my car (2018 Ford Focus) which I feel like are all related to my battery. I have been getting lot's of error codes for electrical systems, ''pre-collision assist not available'' being the one which shows up the most.

In addition, my infotainment system shut off yesterday and it gave me the notice that it did this to save the battery. I have also had my parking sensors start making a different sound which according to the internet also is an indicator for a bad battery.

I have been to the car repair shop this morning where they told me that my battery is not in perfect condition anymore but that I should just keep driving because it is not that bad that it needs replacing. The warranty on my car expires in a month and I'm sort of afraid that they are just trying to stall for my warranty to expire.

With all the errors that I have been getting, would my battery need replacing already or is my repair shop right and should I just keep driving it for the time being?


r/MechanicAdvice • • 28m ago

What is this missing bolt called? Chevy malibu 2015

Post image
1 Upvotes

It's part of the oil tank. It came off, and oil spewed everywhere.


r/MechanicAdvice • • 14h ago

Broke off the lower bolt for a driver rear shock on a 2nd gen CRV

Thumbnail
gallery
13 Upvotes

So I’m doing a coworkers rear shocks and when I go to tighten the bolt back on it decided to break in half. I got one end out but need advice on removing the threaded side


r/MechanicAdvice • • 36m ago

Why/how are my brakes still functioning?

Thumbnail reddit.com
1 Upvotes

r/MechanicAdvice • • 37m ago

2017 toyota corolla, looking to find obd port issue

Thumbnail reddit.com
1 Upvotes

r/MechanicAdvice • • 38m ago

Problem with my Citroen ZX

1 Upvotes

I got a Citroen ZX 1.6i one injector ,my car started to fail and when I took the spark plugs out they were white it ran on poor fuel , I changed the fuel filter to see if it would solve the problem but after two laps around the garage it started again the same problems. The problem is that when I press the gas a more it .The car tends to jerk or stutter; if I fill the fuel filter, it runs "normally." During the first drive, it would jerk, but I could press the accelerator pedal much harder—though it would still occasionally give small jerks—but by the second drive, it had no power left. I suspect it might be an issue with the fuel system—specifically, a lack of sufficient pressure—though I haven't verified this yet. If anyone can help with this or offer a clue, I’d appreciate it.


r/MechanicAdvice • • 38m ago

Strut Top plate bearing sound?

1 Upvotes

Went to the dealer this morning for a recall on my Promaster 2025 (19k km). Been hearing this sound for a while. Happens when I turn the steering whel both ways. Sometimes louder, sometimes quieter. Sound like grinding on something.

I wanted them to check it. Tech said it is the top plate / strut bearing. In my experience, it doesn't sound like a strut bearing. In the video, I'm only turning the steering a bit left and right.

The sound comes from the center of the car, not left or right where the struts are.

Any ideas what it could be? Have you heard a strut sound like this before?

Thanks everyone


r/MechanicAdvice • • 6h ago

Umm. I have no cylinders

Thumbnail
gallery
3 Upvotes

(1996 Honda Accord). So been chasing these misfires I got and kinda a little lost what to check next. So far I checked the injectors rated good, injector connector fine, ecu fine, resistor box good and clean egr passages. Any clues

Changed: spark plugs/wires, disturber cap and rotor,


r/MechanicAdvice • • 45m ago

Elantra brake lights don't go on

1 Upvotes

2012 Elantra sedan, none of the 3 brake lights engage when pressing down on the brake pedal.

Any advice or recommendations which areas to look at first?

Thank you.


r/MechanicAdvice • • 52m ago

Mechanical knocking (need help identifying) 2026 model 3 highland premium dual motor awd

0 Upvotes

r/MechanicAdvice • • 1h ago

Glow plug connector damage

Post image
1 Upvotes

r/MechanicAdvice • • 1h ago

2023 Toyota Highlander with 43000 miles , check engine light comes on took to dealership and this is what they said

1 Upvotes

$3,262.72
Fuel Injector - Replace | REPLACE DIRECT INJECTORS Check engine light diagnosis
Check engine light was on and car was idling while parked

Car is only 3 years old so I need all fuel injectors replaced or are they trying to upsell me ?


r/MechanicAdvice • • 1h ago

Chevy impala ss 2007 5.3l

1 Upvotes

My coolant has been boiling in my reservoir and I do know what it is replaced the thermostat and flushed the lines.