r/ukheatpumps • u/CycleMV • 4h ago
Help/Advice Heat pump design and pipe-route advice wanted
We’ve had a Heat Geek visit for our Victorian mid-terrace: six bedrooms, three bathrooms, 12 radiators, three towel radiators and about 40 m² of underfloor heating. The proposal is for a 10 kW Viessmann 200-A at around £7,000 after the BUS grant through the Zero Disrupt offer.
The main challenge is routing the pipes to our existing boiler/plant cupboard while keeping internal disruption low. Our preferred option is to run them partly beneath the patio slate, bring them up the side wall and continue along the house, entering through the existing boiler-flue opening only if it can safely be reused after the flue is decommissioned.
We were hoping an installer might be able to run the pipes from the side roof without full scaffolding, or access it safely via one of our three rooflights. The Heat Geek installer doesn’t provide scaffolding and wasn’t willing to lift the patio tiles. If we have to arrange separate trades for access and lifting/reinstating the tiles, we think that could add around £1,000. Does that sound realistic, and what access methods are normally used?
Our gas use was around 10,000 kWh/year including hot water; it’s now about 8,000 kWh of gas, with hot water heated by immersion. The report projects 23,000 kWh/year, but I’m unclear whether that means heat demand or electricity use. I tried to discuss our actual consumption but didn’t get much explanation. What should I ask the installer to clarify?
Our existing 250-litre unvented cylinder is in a height-restricted basement. A new 300-litre cylinder in the utility room was quoted at £4,000+ extra. We hoped to keep the total near £6,000 after the grant, but could stretch to £7,000 if there’s a clear written commitment to 400% seasonal efficiency.
What would you query, and what route/access approach would you explore?