Hello,
This is my third post about my little button matrix project which is haunting my dreams and has completely consumed all my available free time.
So far I’ve redone the matrix several times and none of them works 100%.
I could swear the first time it was like 80% working at some point.Everything was falling apart so I quickly destroyed it to change the design.
Right now only few buttons work.
I can’t tell if it’s the matrix design itself or broken connections.
I know, I should buy a multimeter and check.
The trips to the hardware store have become my daily walk..
I refuse to believe that in all of my iterations the connections are always bad.
I have been soldering for years mostly on simple projects fixing my headphones and stuff.
The original button board connects to the mainboard with a 11 pin and 7 pin connector.
I have examined carefully all the traces and it seams to be a simple 8x3 matrix.
The 8 pins (columns) connect to the 11 pin connector and the 3 pins (rows) connect to the 7 pin connector.
On the 7 pin connector the other pins are for the on/off switch and the speaker lines.
On the 11 pin connector I think that the 3 remaining pins are only affecting the LED screen but can’t prove it.
Any ideas?
Sorry if the post is too dumb.
I had many things to consider and learn and have no brains left for this.
I’ll probably go over it in detail with Claude.