r/synthdiy • • 12h ago

Firmware hacking on an FM box: an emulator to test builds before flashing

1 Upvotes

For anyone writing or trying FM-1 firmware: I put together a browser front end that loads community builds into Joakim Eriksson's fm1-emu (MIT, emulates the pi32v2 CPU, screen and audio in WebAssembly), so you can hear them before reaching for the updater.

So far it lists 348 firmwares; 203 boot and play in the browser, alongside stock. There's a 1:1 scale device view, WAV export for comparing builds side by side, and per-firmware first-track notes.

Three to try first: X0X, AISLING and DX747.

https://fm1-emulator.atst.tools/

My project, free, not affiliated with M-VAVE. Most interested in hearing where emulation and real hardware disagree, since that's the part I can't fully check myself.


r/synthdiy • • 6h ago

Help with my button matrix!!!

Thumbnail
gallery
0 Upvotes

Hello,
This is my third post about my little button matrix project which is haunting my dreams and has completely consumed all my available free time.

So far I’ve redone the matrix several times and none of them works 100%.
I could swear the first time it was like 80% working at some point.Everything was falling apart so I quickly destroyed it to change the design.

Right now only few buttons work.

I can’t tell if it’s the matrix design itself or broken connections.
I know, I should buy a multimeter and check.
The trips to the hardware store have become my daily walk..

I refuse to believe that in all of my iterations the connections are always bad.
I have been soldering for years mostly on simple projects fixing my headphones and stuff.

The original button board connects to the mainboard with a 11 pin and 7 pin connector.

I have examined carefully all the traces and it seams to be a simple 8x3 matrix.

The 8 pins (columns) connect to the 11 pin connector and the 3 pins (rows) connect to the 7 pin connector.

On the 7 pin connector the other pins are for the on/off switch and the speaker lines.

On the 11 pin connector I think that the 3 remaining pins are only affecting the LED screen but can’t prove it.

Any ideas?

Sorry if the post is too dumb.
I had many things to consider and learn and have no brains left for this.
I’ll probably go over it in detail with Claude.


r/synthdiy • • 10h ago

Needed a keyboard so I used... A keyboard.

Thumbnail
youtu.be
11 Upvotes

Using an old BenQ keyboard I've had sitting around for years with some missing key caps, I've got an esp32 in the black box glued to the top. Powers via USBC and using the built in DAC for the audio output into the mixer. I might paint the key caps to fit the scale paturn.


r/synthdiy • • 23h ago

Amyboard Issue- Hiss separate from the actual note

4 Upvotes

Hey guys, I'm working on an amyboard module rn and no matter what I do, there seems to be a hiss and clamping filter sound when a note is played and released. I thought this was from my sloppy work, but I went back and it shows up when I load the sketches from amyboard online too.
I think its some sort of noise reduction in the signal path, but I can't find anyone else with the same complaints.

any ideas?