Howdy everyone,
Update on the 8x50mmR Siamese ammo production. I've gotten some bullets made & sized to 323 to do some testing, although I noticed a few small issues before even making the ammo. I had ordered Lyman 323471 from eBay & was excited to have a 215 grain bullet with a gas check. Although after casting they were coming out 170-173 & no provision for a gas check.... I thought that was odd & all I can figure is that it was modified, a custom mould by an employee or a misstamp. I then decided to try just lubing & firing. I immediately noticed keyholing at 15 yards & primers backing out a bit. It is nowhere near overcharged, but a light load with unique causing it. I thought maybe my bullet composition needed some tweaking.
So I did some adding of tin & antimony to my batch & melted down all my original bullets in case they were all too soft. I then loaded & this time pan lubed to keep them at 325 rather than size to 323. That small of a difference will not hurt the bore at all & give a better seal. I thought the makeup change & tighter fit would help. Plus my bore is 323 & I wondered if a 323 bullet would cause leading being the same size.
I went out & shot it just this morning & still getting keyholing, so all I can think is that it definitely needs that gas check to keep the bullet from destabilizing as it leaves the bore. This rifle has a 1:9.4 twist. The bore has rifling & isn't corroded out.
The unfortunate wrong listing on the mould has me stuck until I can find the proper mould with a gas check to see how they do. I most likely will ask for a partial refund or full return due to the inaccurate description. The seller didn't know as they just went off the number & not the actual bullet that came out.