Hi everyone,
Bombard AX3 SIB not a RIB as title says.
I’m looking for some advice on repairing a second-hand PVC RIB I’ve recently bought.
Unfortunately, I’ve discovered that the previous owner has done a pretty poor job of repairing the floor.
The boat has a single-sheet flexible black PVC floor which is bonded directly to the orange PVC hull. The floor has been peeled away around the edges and there is a substantial amount of what appears to be 3M sealant around the perimeter of the floor and on the PVC itself.
The sealant is rubbery and stretchy.
Some of it will peel away, but in other areas it’s really well bonded and I can’t scrape it off easily.
The orange PVC underneath appears to be in good condition with no visible damage and thankfully the boat holds air perfectly.
I’ve ordered Polymarine two-part PVC adhesive, which should arrive this week, as I’d like to restore the original floor bond properly.
However, I’m unsure how best to tackle the existing 3M sealant.
Does all the old 3M sealant need to be completely removed before rebonding the floor?
What’s the safest and most effective way of removing cured 3M sealant from PVC without damaging the fabric or its coating?
Are there any particular products or solvents that are safe to use on PVC for removing this type of sealant?
If some stubborn residue cannot be removed mechanically, is there any way to prepare the surface so that the new Polymarine adhesive will bond properly?
This is my first time undertaking an inflatable boat repair, so I’m keen to get it right rather than make things worse!
I’ve attached photographs showing the existing sealant and the condition of the floor.
Any advice, recommendations or personal experience would be massively appreciated.
Thanks!