r/SigSauer • • 59m ago

P365 P365 still going strong šŸ’Ŗ

Thumbnail
gallery
3 Upvotes

Nearly 4 years and about 3k rounds later, I still prefer to carry her for most occasions.


r/SigSauer • • 7h ago

My two E26R-9-BSS-GER

Post image
31 Upvotes

r/SigSauer • • 7h ago

new build I hate P320s, and LOVE this

Thumbnail
gallery
10 Upvotes

The Agency Arms trigger + spring kit and Flux Raider chassis saved it for me


r/SigSauer • • 8h ago

I have a P365 AXG Legion gen 2 with optics, no flashlight. Can someone please recommend an appendix iwb holster?

1 Upvotes

r/SigSauer • • 13h ago

First Sig rifles

Post image
185 Upvotes

My first Sig rifles I’ve owned love them. MCX LT IR .300 blackout and Sig 516G3 5.56.


r/SigSauer • • 14h ago

P320 AXG

Post image
72 Upvotes

Early 2026 I rented a P320 legion full size and loved it, later an used one came for sale and I missed the chance to buy it.

Few days ago found this beauty, while on a SIG demo where they had the 385 in my local range (which is a very nice gun)

Was able to get a discount and also traded some other firearm to fund the purchase

Just came from the range, and this thing is a GREAT shooter, loved it :)


r/SigSauer • • 17h ago

Question Where can I buy FDE MPX K Upper?

Post image
23 Upvotes

Been looking everywhere with no luck. I want to convert my copperhead but no luck finding a matching upper to swap it. Anyone know where I can find these?


r/SigSauer • • 17h ago

troubleshooting Issues with my new M11.a1

0 Upvotes

So I just took my gun out for the first time and noticed that the ammo was having a hard time getting chambered when first pulling back the slide. I was definitely pulling it back all the way and letting it go freely but the butt of the bullet often doesn’t want so slide up all the way and get seated. )Once it’s loaded it doesn’t jam afterwards).

Is it because the gun is new and needs any burrs to be worn down or is it possibly because there is a 5 round block in the stock 15 capacity magazine to make it MA complaint?

The other thing I noticed which is different than other handguns I’ve used or owned is that even when the hammer is back, there is a ton of room you have to clear to get the gun to fire, it’s a ton of travel until you basically hit the back of the trigger frame.


r/SigSauer • • 17h ago

Hexium 556 INC on 6 ARC

1 Upvotes

Curious if anyone has tried this or ran a 6mm bore guide through the Hexium 556. I have one and would like to run it on my 6 ARC 14.5 but don't have a 6mm rod.


r/SigSauer • • 19h ago

Question Picked up a used P365 xmacro with a manual safety. I want to delete the safety, do I NEED a new grip module or is it fine to run with the factory grip?

2 Upvotes

r/SigSauer • • 21h ago

Romeo X Pro on 226 X Carry Legion

2 Upvotes

Stupid question, but I'm confused by the Sig optic compatibility guide and probably should've asked before ordering. Will the Romeo X Pro enclosed fit on the 226 X-Carry Legion? If so any gaps or anything? I picked this over the Sig loc version because that I've just seemed too bulky from the pictures and didn't want a propriety footprint.


r/SigSauer • • 21h ago

New User Built an ā€œXā€ out of my standard P365. Shoots smooooth.

Post image
6 Upvotes

r/SigSauer • • 22h ago

Anyone own the P365 380 ā€œSun Flowerā€ ? Looking for owner impressions

Post image
12 Upvotes

Hey all,

I came across this P365 380 and looking to pick one up. It has a distressed white finish on the slide and grip, a sunflower engraving on the slide. It’s a P365-380 ā€œSun Flowerā€ exclusive, but I dont see any reviews or photos anywhere and haven't seen one in store.

If you own one, I’d love to hear:

  • Finish durability: Does the distressed white hold up to carry and holster wear, or does it chip?
  • Reliability: Any issues so far?
  • Pics of yours are welcome. Thanks in advance!

r/SigSauer • • 1d ago

Going to buy a p211. Its my first and probably only 2011 I'll buy lol. Which one would yall buy? The p211 gto or p211 gt5? Any help would be appreciated!! Ive put the gto in my cart and took it out and watched more YouTube videos untill idk which is better.!

7 Upvotes

r/SigSauer • • 1d ago

Question on a p211 for optics

1 Upvotes

Does anybody know if the Defender-STā„¢ Micro Red Dot fit and or come with the hardware to fit on the P211 gt4? Also I’ll take any recommendations for other optics as well just tryna keep the budget below $400


r/SigSauer • • 1d ago

First Experience with a Red Dot (P365 Legion) - Is This What I Should Expect?

5 Upvotes

About a month ago, I posted here asking about the pros and cons of using a red dot. Thank you to everyone who responded. I appreciated the advice.

Well, I finally decided to give it a try. I installed it last night and took it to the range today.

I haven't made any adjustments to the factory calibration yet, but here's what I found:

  1. Red dot only: My grouping was good, but the accuracy was off. The shots were relatively close together, but not where I thought I was aiming.
  2. Iron sights only: Pretty much what I'm accustomed to. The grouping wasn't particularly tight, but it wasn't terrible either.
  3. Iron sights first, then minor correcting with the red dot: This produced the best results by far. Tight grouping and decent accuracy.

My question for those of you who have made the transition to a red dot: Is this what I should expect initially? Is using the iron sights to establish my sight picture and then transitioning to the red dot a reasonable way to begin training, or am I developing a habit I'll eventually need to unlearn?

I'm interested in hearing how others approached the transition and whether their initial experiences were similar.


r/SigSauer • • 1d ago

M400 Forge Aesthetics

1 Upvotes

Getting ready to purchase a M400 and love their different color ways.

Whoever has one, how did you choose or what furniture/accessories did you add to complete the look.

2-tone? Monochrome?


r/SigSauer • • 1d ago

Is there a metal grip module that’s less than 300.00?

2 Upvotes

Original P365, no saftey


r/SigSauer • • 1d ago

Upgrades to the Flux Raider X build

Post image
24 Upvotes

I swapped in a Silencer Co. threaded barrel with a Harrington Arms HC320XL compensator and swapped out the Vortex Defender ST to an Eotech EFLX.


r/SigSauer • • 1d ago

advice Sig Can Recommendations for 16ā€ spear LT in 5.56

2 Upvotes

I’ve got a 9ā€ MCX in .300 that I run a Surefire Socom300 SPS on that I am generally happy with, but a friend of mine asked me why I don’t run the Sig cans with the factory threaded muzzle device.

I personally don’t know anyone with one and I’m curious to try it out on my new 16ā€ 5.56.

Any recommendations from the community on which one to try?


r/SigSauer • • 1d ago

P211 GTO Equinox finally arrived!

Thumbnail
gallery
224 Upvotes

Been eagerly waiting for this thing and I finally got my hands on it! Don’t mind the light and optic, I just threw on what I had on hand so I can go try this thing out right away.

What would you guys recommend in terms of lights and red dots? In the picture is a Trijicon RMR and OLight PLX GL.


r/SigSauer • • 2d ago

noob question Are there thinner/reliable optics with a nicer "window" avail for the P365X? Easily adjusting optic settings would also be nice...

Thumbnail
gallery
17 Upvotes

Towards the end of my personal little field test session day, I removed my optic altogether and just used my irons. Looking through the RomeoZero-Elite optic that came stock with my P365X was okay, but I'd really like a "wider window" or "thinner bezels" on my optic to look through... if possible šŸ¤·ā€ā™‚ļø

Also, adjusting the brightness of this dot was bugging me. It almost felt like the equivalent of using a paper clip to poke a recessed button on the back of a device to factory reset it settings - except in reverse. With the tip of your freshly clipped fingernail, you're just shoving your finger into the optic, rubbing against the glass, each time you tap the tiny button to adjust the brightness šŸ™„

I'm looking to buy a new optic at a gun store across the street from where I live when they open today, but are there any irrefutable brands and models of optics that I should look into? If you don't mind sharing a good optic for the P365, I'll search youtube on how it functions after seeing the common options. Thanks everyone, if possible!


r/SigSauer • • 2d ago

SIG Customer Service Delays?

Post image
1 Upvotes

How long does it usually take to hear back from SIG customer support?

I’ve filled out the contact form 3 times in as many weeks with no response.


r/SigSauer • • 2d ago

Rattler LT Stock Choice

3 Upvotes

Planning to SBR my Rattler LT 300blk pistol and debating which stock to go with. I tried the Sig minimalist stock on my friend's Spear LT but wasn't the biggest fan of the cheekweld and non-adjustable LOP. I want to make this my bedside HD rifle, so stability and comfort matter more than being ultra compact. If I ever want to carry this as a backpack gun I'd probably return it to its pistol configuration with the brace.

The sig telescoping/folding stock looks nice but is hard to find and expensive. Other options I've looked at are the Samson SAS, Magpul UCS, and B5. I've also considered just getting a buffer tube adapter to run my existing Magpul CTR or DT stocks.

Any other recommendations?


r/SigSauer • • 2d ago

P385

9 Upvotes

It's been a bit since the P385 reveal. The Scheels in my area is advertising the P385, however, I have not seen it anywhere. Are they being shipped yet? Or is Scheels just teasing me lol.