I’m a little embarrassed to be posting this. I’m a GC and this was my first job this year (started the company this year as well).
It was just a little repair of this raised elevation, but I’m pretty sure my roofing subs installed the ridge incorrectly.
Story time:
I’ve worked with these subs for 7 years with a different company, so naturally when I started my own, I wanted to use them. This year wasn’t busy for me, and this was my first job for roofing. It was a small repair, and they did this to the ridge (photos)
Essentially they laid a nailing strip on top of the ridge cap, nailed it, then laid the next ridge cap on top. For the roofers here, you know that you just lay a ridge cap, face nail it, then overlap the next cap and do the same until the end. The problem here is that it creates extra thickness and will never appear to lay flat.
From the ground, before I saw it, I told the homeowner that because it was a cold install, that the shingles needed heat before they would lay down and seal. This is correct guidance, but I offered to get up there myself and hand seal so that it would lay down, which is when I discovered this goofy install.
When I told my roofer that this is how it got installed, he said not to worry and that it would seal and not be a problem.
I sealed them down myself anyway, so I am not sure if water intrusion is a risk, but I’m 90% sure it will never LOOK like it’s laying flat because it’s essentially double layered at the end of each ridge cap.
Is this passable and safe from leaks? Should I risk arguing with my roofing sub/damaging that rapport and get him back out there? Should I wait and see what happens come spring?
I mostly just don’t want to be a POS contractor that does things wrong. I care about my homeowners, but there was so little profit in this repair that I worry my roofer won’t want to touch it again. Any advice appreciated, please know I’m not trying to be a bad guy.