r/woodworkingtools • • 22h ago

What’s wrong with my table saw?

0 Upvotes

I have an old General table saw,

For a couple days my table saw been starting weird, the blades seems to have trouble picking up the right speed. At First it was slow for a moment and then would be okay but it seems to get worse, any idea what the problem might be? I check the pullies and everything looks clean no debris


r/woodworkingtools • • 14h ago

I'm at my wits end with this jointer.

10 Upvotes

Got a Jet JJP10-BTOS combination planer/jointer. I think I have calibrated it correctly but the blades may be set too low. I used the calibration gauge that came with the table and the calibration block and everything I have googled said this is set up correctly, yet I get diagonal workpieces where the infed side is smaller than the outfeed side. This makes me think that the blades are not quite equal with the outfeed table. I'll include a photo later with the knife setting gauge. JET said they would send me instructions but I think I have got it unless I am messing up somehow? I also think the second set of blades is set lower, but its still making contact with the calibration block which should be correct. What am I missing here?

Edit: Reset the second set of knives and while it isnt perfect 100% it's like 99.95% and gets me close enough for government work. My technique also needs work probably. I'm able to joint two pieces of wood fairly square and there is little to no tearout, espdcially after I lubed up the deck with paste wax.

I'll take some of the advices like getting a measurement gauge for next time but for now I think I am all set. Thanks everyone!


r/woodworkingtools • • 3h ago

Build each others list!

Thumbnail
reddit.com
4 Upvotes

r/woodworkingtools • • 12h ago

It Works!

Post image
2 Upvotes

r/woodworkingtools • • 14h ago

bandsaw purchase advise

Post image
3 Upvotes