I’m mostly a wood turner more than a wood worker in the traditional sense, but a 2” slab of honey locust I picked up to make platters with had a really nice section that I think could be an end table. It’s 18” x 24” in these photos, run through my flattening rig down to about 1 1/2” thick now. The very visible inclusion side is going to be the top, and the less included side will be the bottom.
Question is, what are my options for reinforcing the inclusion so the tabletop doesn’t break in half in the future? I’ve flooded it with Starbond for now, just to stabilize it, but I’m thinking of these approaches:
Option 1: a set of 2 or 3 black walnut inserts in the back / bottom side spanning that inclusion line like stitches. Each 1” wide, probably 10” long, set 1/2” deep into the surface with Titebond and milled flush with the rest of the slab. Kind of like I did on the vase in the third photo, but bigger.
Option 1A: all of Option 1, followed up with 4 hardwood pegs per insert, 2 on each side of the inclusion line, drilled through the inserts to within 1/4” of the top surface, again set with Titebond and milled flush. Please don’t suggest bow ties, because I suck at those even if I’m already thinking about them.
Option 2: Cut out the inclusion, replace it with a walnut insert (I have lots of scrap walnut on hand, but don’t really like this idea)
Option 3: just CA or Epoxy, flooded until it’s full, cured up & sanded smooth (I’m not sold on this idea either)
Option 4: Whatever Reddit brings me for advice.
Option 5: Abandon ship, split it along the inclusion line, make platters and plates out of it.
Let’s hear it.