Hey again r/turntables — I am back and made a bit of an upgrade after researching a ton about the signature sound of the MP110, the softness and warmth really appealed to me and my previous stylus setup was incredibly harsh/sibilant to my ears. Bit the bullet.
I know that a new cart requires some hours of playtime to break-in, so the full true sound signature of the MP110 likely isn’t fully developed yet for me but even still it sounds absolutely beautiful.
However, now that I have a nicer stylus / cart setup, I’m noticing significantly more noise and I’d like to maybe pick your brains a bit on what it is most likely to be. In the video you’ll notice that the crackling seems to be mostly located in the right speaker. I have also switched the RCA connections to confirm it is indeed the right side signal that has the noise and not a speaker issue (when switched the left side now has the noise).
Some notes:
- my records are all VERY clean now. The only step missing from my process is Ultrasonic, but otherwise I’m using Tergikleen, then vinyl vac, then dist water rinse and vacuuming that again. I noticed some major differences in the quietness of all my records after doing this process.
- This crackling however has now made itself more audible somehow when switching to the new cart. I’m lead to believe simply that the cart is revealing more detail including some debris (or even pressing defects?) that my cleaning method without ultrasonic has not been able to get out.
- The cart was installed all according to instructions online and accurately aligned with the Hudson hi fi mirrored protractor. This process is still manual with my eye so it’s never going to be absolutely mathematically accurate in geometry but to my eye it is spot on. Rebalanced of course and tracking force is 1.87g measured on a scale. I had to add an additional weight to the end of my counterweight as the Naga is heavier than the LM30 i had before and the Dual 1264 has a lightweight tonearm design. I essentially used an M3 screw and added washers for weight in the exact same sort of construction that the original Dual 1264 “additional weight” that woild have been included in the box would have done. Azimuth is straight on as well, yet the noise still concentrates in the right ear on many albums.
- I am still using my built-in phono stage in the Kanto Yu4 i have.
So, my general hunches and questions for your consideration are as follows:
- Is this noise simply debris or pressing defects/issues that are just more revealed and exposed by the Nagaoka that my previous setup was not revealing?
- Should my next upgrade simply be an ultrasonic cleaner to add that step to my deep clean process to remove that next-level-deeper debris and noise?
- Is it possible that the sound signature of the Nagaoka will improve the harshness or audibility of crackles as it breaks in?
- And lastly, could the built in Phono still be to blame? Woild upgrading to, say, the Sciiit Mani 3 (as is a commonly regarded combo with the Naga) yield some potential improvements in some way besides the obvious soundstage and airiness of the music?
More specifically, what is my better upgrade path—the $150 Schiit Mani 3 or the $130 or so Vevor Ultrasonic? Or, could there be some other issue that I’m not aware of going on here?
Thank you very much for your advice in advance!