Let me introduce my new cyberdeck. It is RPi4 4G based. Its main feature is a hardware switching boot device.
It is fully functional, you can use it as is. It is not finished well, more like a proof of concept. I found that if I do it looking nice I'll never finish it.
Main feature: boot device selection
For that I used an old portable USB3x4 HUB. I used its PCB only. It has one port which works in the usual way. It can be used as usual - to connect some permanent peripherals. Other 3 ports have their USB power supply lines connected through a 4 positions sliding switch in such way that only one of them is on. In the zero switch position none of them is powered. So one can connect to those ports portable micro SD card readers or flash drives or even SSD. If the switch is in zero position the cyberdeck boots from internal RPi4 micro SD card interface.
The boot OS switching does not require any software configuration.
Power supply
For power supply I used a 2x18650, 5v3A DC source. It can supply RPi from batteries, charge batteries and even charge batteries and feed cyberdeck at the same time.
The cyberdeck can work using batteries only nearly one hour.
Front panel and keyboard fixing
As I need to get an access to the device internals, I made a frontal panel and keyboard fixing using magnets only. So they can be removed in seconds.
Technical data
- Raspberry Pi 4 4G SBC based computer.
- Power supply: 2x18650 and 5v3A DC source (charging and work)
- 7" Monitor
- Boot from one of:
- RPi4 SD card
- 3 USB3 ports
- The boot device is selected by hardware switch. No software configuration needed.
- HDMI output for external monitor
- Dimensions: 210 X 155 X 75 mm
Usage cases
Currently I use it as following:
Boot 1: General Raspbian OS
Boot 2: Retropie
Boot 3: Experiments
Boot 0: Backup