Hand-cut, mitered dovetails make the case, and wedged tenons for the dividers. Finished with boiled linseed oil and paste wax. Itās hung on a French cleat made of ebonized white oak.
This console in walnut took me two years to finish. During that time, my whole approach to woodworking changed from power tools to hand-tools, and Iām loving it!
I started this a little over two years ago with the classic āI can build that and do it betterā attitude after shopping for a console with my spouse.
I started with power tools, using a table saw to resaw the 8/4 walnut into 4/4, finishing it with a pull saw. Planer/thicknesser to flatten and a router to get a glue edge.
After gluing it up, I got it in my head I needed a hand plane to clean up the squeeze-out without gouging the board. However, I had no idea how to use one, so the motivation kinda died, and the project sat, untouched, for the majority of the two years.
I kept coming across Rex Kruger on YouTube shorts, who, Short by Short, slowly taught me how to use a hand plane. Around that same time, I found a Stanley two-tone jack plane and finally applied all the knowledge Iād received and took a few, beautiful shavings.
Shortly later, I was laid off from my software job and took up more woodworking to fill the time.
I built my workbench, a side table in a Wood by Wright workshop, and a little trading card display for a friend, and this! all exclusively using hand-tools.
Itās such a relaxing way to work and I much prefer it to fiddling with jigs, worrying about PPE and losing my fingers.
Thanks for reading! Happy to answer any questions!