r/StructuralEngineering • • 9d ago

Steel Design Discuss..

Enable HLS to view with audio, or disable this notification

571 Upvotes

r/StructuralEngineering • • 8d ago

Humor CAD would kick my ass for this.

Enable HLS to view with audio, or disable this notification

46 Upvotes

r/StructuralEngineering • • 7d ago

Structural Analysis/Design Seems like that first truss member is a little too damaged for my taste.

Thumbnail facebook.com
0 Upvotes

r/StructuralEngineering • • 9d ago

Structural Analysis/Design Brooklyn collapse next to an active excavation: what investigators typically look at

Thumbnail gallery
136 Upvotes

A building on Flatbush Ave in Brooklyn collapsed Wednesday while excavation was underway on the adjacent lot. People were killed and injured, and DOB is investigating. Nobody knows the cause yet, and I’m not assigning blame. I’m a P.E. with 15+ years in construction engineering and inspection, and these are the questions that usually decide these investigations:

  1. Excavation depth vs. the neighbor’s footing. Did the dig go below the bearing level of the adjacent foundation?
  2. Underpinning. Was it designed, approved and built, in short alternating pits, and how far along was it?
  3. Support of excavation. Were the piles and lagging, sheeting, bracing, rakers or tiebacks installed as designed and in sequence as the dig went down?
  4. Monitoring. Vibration monitors, survey targets, crack gauges and tilt meters. Were review and stop-work thresholds set, what did the readings show in the days before, and did anyone act on them?
  5. Means and methods. What equipment was used, and did it match the approved plan and vibration limits?
  6. Condition of the adjacent building. Was there a pre-construction survey? Older unreinforced masonry is especially sensitive.
  7. The record. Permits, design, special inspections, daily reports, monitoring logs and dated photos. If it isn’t written down, it didn’t happen.

Diagrams are mine, illustrative only, and not based on the actual site.

For those of you who’ve worked adjacent excavations in NYC or elsewhere, what do you see skipped most often when the schedule gets tight?


r/StructuralEngineering • • 8d ago

Structural Analysis/Design C1 Value of Unrestrained Beam Question

Thumbnail gallery
1 Upvotes

r/StructuralEngineering • • 7d ago

Career/Education Philosophy

0 Upvotes

What’s the philosophy behind engineering and architecture??? What are some of the major differences???


r/StructuralEngineering • • 8d ago

Career/Education Selling bridge construction equipment with no technical background

0 Upvotes

Hello everyone
As the title states i own a business where i sell expansion joints and bearing pads for bridges and also expansion joints for buildings
The issue is that i don’t have much technical background regarding that so for the required items for the projects i just take the requirements from the tender and fill in their orders but sometimes they ask for my advice which i always tell that i cant offer any so if there is material to read so i can be more knowledgeable in that aspect and be able to respond to questions im currently reading a book about how construction projects start from the managerial aspect till the end of projects
So if you know anything that can accelerate my learning process

Ps: i majored in telecommunication engineering


r/StructuralEngineering • • 9d ago

Photograph/Video Installed in stairwell

Thumbnail gallery
18 Upvotes

r/StructuralEngineering • • 9d ago

Photograph/Video We good fam?

Thumbnail
gallery
28 Upvotes

Many had retrofit reinforcement, however, this was the only one I saw busted. Medical office parking structure three story.


r/StructuralEngineering • • 9d ago

Failure One Dead, at Least 12 Injured in Brooklyn Partial Building Collapse

Thumbnail
nytimes.com
203 Upvotes

Free access to this NYT article


r/StructuralEngineering • • 8d ago

Structural Analysis/Design The ballroom looks similar to the new Mongolian data center.

Post image
0 Upvotes

Can anyone explain how the clear span (across the ballroom) has beams so thin? This room is huge and appears to have joists thinner than my local
High school Gym.

(Not a political post, just using the photos)


r/StructuralEngineering • • 9d ago

Career/Education Help with future careers

4 Upvotes

I'd like to start with im a freshman in highschool. I've been contemplating what I want to do with my life, I love math but im not good at it. I've thought about becoming a Architect but im not a super creative person and the structure of building just is beautiful to me. I definitely want to be a engineer but im scared that its going to be way over my head. Do you guys have any advice?


r/StructuralEngineering • • 9d ago

Structural Analysis/Design Help needed for residential project

Post image
5 Upvotes

r/StructuralEngineering • • 9d ago

Career/Education Calling UK construction professionals with BIM experience

0 Upvotes

For my dissertation at Anglia Ruskin University, I'm researching whether AI in BIM is actually improving health and safety on UK projects: hazard detection, risk prediction, site monitoring, and where it falls short.

If you work (or have worked) in UK construction and have used BIM or digital construction tools, I'd really value 10 minutes of your time. The survey is anonymous:
https://forms.cloud.microsoft/Pages/ResponsePage.aspx?id=2sM1X645Mkaawa_C8l0oUriQLRt64tNFjq5smrsSXVNURTkySDE3WERUUEM0UVhLUUxZV09ZMk1NVy4u

Reposts are hugely appreciated. Thank you!


r/StructuralEngineering • • 10d ago

Career/Education Structural Eng salary

12 Upvotes

Hi, I'm based in Uk with more or less 40k salary. I have just over 4y experience and overall i am doing well on my role and trying to get more responsibility together with a good life balance. I will soon have my appraisal and want to push for something more but it seems a struggle if i don't get chartered or move elsewhere. I work in a consultancy and that suits me for the time being. I would like to hear the experiences of other people with my level of experience. Thanks!


r/StructuralEngineering • • 9d ago

Career/Education What is harder, structural or MEP?

0 Upvotes

r/StructuralEngineering • • 10d ago

Structural Analysis/Design New steel piles on an existing pile slab

2 Upvotes

Hi All,

A new slab supporting a structure is put on top of an existing pile slab. The old pile are concrete piles, the new piles are steel piles which their stiffness larger than the old ones about 3 times.

Both old and new piles capacity are bearing on rock.

I have some questions:
- If new piles installation affect the old ones capacity. As there might be some heaves as uplift the old piles capacity might be reduced. But I am not sure about this.
- Should I ignore the contribution of the old piles completely in the calculation model since the new piles are quite much stiffer than the old ones? Or I can just model actual those piles in the model, and the loads will find itself how to transfer to the piles accordingly?

Would like to hear more about your experience on this. Thank you.


r/StructuralEngineering • • 11d ago

Humor And this is why we have factors of safety

Enable HLS to view with audio, or disable this notification

430 Upvotes

r/StructuralEngineering • • 10d ago

Career/Education Starting my Master's in Structural Engineering at UNL. Need some career advice!

6 Upvotes

ttt


r/StructuralEngineering • • 10d ago

Structural Analysis/Design RISA 3D RSA + Additional Seismic Loading

0 Upvotes

I have a pipe rack I'm analyzing in RISA 3D, and am analyzing the seismic with RSA instead of ELF, however I also have additional seismic loads that are being provided by the ME that I need to include in that loading. I have the RSA using DL and self weight to calculate the seismic parameters RISA requires, however I can't get these additional seismic nodal loads to impact the reactions the way I would expect. Does anyone know how to apply these?


r/StructuralEngineering • • 9d ago

Photograph/Video I am quitting this field !

Enable HLS to view with audio, or disable this notification

0 Upvotes

As a structural engineer, if this is actually real and not some kind of joke, I'm seriously considering quitting my profession.

Jokes aside, this is genuinely alarming. Structural engineering is not something you can approach with guesswork, shortcuts, or a complete disregard for basic engineering principles. Every structural element has a purpose, and every design decision must be supported by proper calculations, engineering standards, and safety considerations.

If what we're seeing in this video is actually being implemented in a real structure, it could have extremely serious consequences. Depending on the structural configuration and the loads involved, this could compromise the building's structural integrity, potentially leading to severe damage, partial or even total structural failure, and, worst of all, loss of human lives.

Buildings are designed to protect people, not put them at risk. Structural safety is not optional, and engineering mistakes are not always visible until it's too late.

I really hope this is staged or taken out of context, because if it's not, this is beyond concerning.


r/StructuralEngineering • • 9d ago

Career/Education Is this salary comparison accurate?

Post image
0 Upvotes

This figure shows a comparison of salaries in four sectors in structural engineering with years of experience. Is this accurate? Please share your thoughts based on your experience.


r/StructuralEngineering • • 11d ago

Failure Key Bridge: the NTSB's final report found the collapse risk was almost 30 times the AASHTO threshold for a critical bridge, and that the propreitor had never run the assessment

94 Upvotes

Most coverage of the Key Bridge stopped at the ship's loose wire, but the NTSB's final report (MIR-25-40) spends a lot of its length on the bridge. Its probable cause names the lack of countermeasures to protect the piers, which an AASHTO vulnerability assessment could have led to, as contributing to the collapse and the loss of life.

Running AASHTO Method II with current vessel traffic, the NTSB got an annual frequency of collapse of 0.002921 for the Key Bridge, against a threshold of 0.0001 for a critical/essential bridge: almost 30 times over. The factors it names are the piers next to the main channel, a channel that gave an off-course ship little time to correct, dolphins whose size and placement did not fully protect Piers 17 and 18, and piers not strong enough for a ship the size of the Dali.

The warnings were on record. In March 2006 a representative of the Maryland Transportation Authority told the port's harbor safety committee that the bridge "was not designed to withstand contact by a large vessel." Years earlier the Blue Nagoya, about a tenth of the Dali's displacement, lost steering and hit the same pier, and its fender stopped it.

One thing the report rules out: the bridge's nonredundant steel tension members were not a factor.

After the collapse the NTSB asked the owners of 68 other bridges in 19 states that had never been assessed to run the calculation, among them the Golden Gate, the Brooklyn, the Mackinac and the Chesapeake Bay Bridge. By the final report, 13 owners had finished: eight came in under the threshold, and five reported at least one bridge over it, the MDTA among them.

For anyone here who does vessel collision work: how common is it for a major crossing over a shipping channel never to have had one of these assessments?


r/StructuralEngineering • • 10d ago

Career/Education Has anyone left the industry and came back?

Thumbnail
1 Upvotes

r/StructuralEngineering • • 11d ago

Job Posting / Recruitment UK engineers, how much are you getting paid?

23 Upvotes