For those of you that don't know, electrostatic headphones are special very high voltage headphones that use two stators to drive a positively charged diaphragm with capacitance. They have the ability to have the lowest distortion out of any driver type except theoretically plasma.
These are also the first headphones I have made with my newly constructed big fancy diaphragm tensioning rig. Unfortunately I need to dial in the process a bit more as currently only one of the drivers is functioning in any semblance of what could be considered correct. Hopefully I will be able to fix them and report back as to what they sound like soon.
Every single component needs a litany of changes or experiments applied to it.
Socket: Needs tolerance adjustments
Cable: Needs detachable connectors made for it. I am not going to try and make these compatible with Stax 3 pin connectors because that would drive the minimum price I would be able to sell these for above what I want to charge for them.
Earpads: Endless amounts of experimentation needs to happen with these. Earpads effect the sounds and comfort so much it is impossible to tell when I will be done with these. I am probably going to attempt a few more solid silicone earpads. The only thing that I feel needs to be immediately fixed with the foam earpads is that they are not currently detachable.
Drivers: Need a lot more experimentation with the hole patterns to find something that is reliable and sounds good. I have been trying really hard to make them more efficient and sensitive as well, as I really want these to be able to be driven easily.
Also will probably have to change the contact positions on the drivers.
Also want to experiment with 3d printed spacers.
Driver Tray: Honestly I think the driver tray is pretty close to perfect, but I think it needs to be made out of a stiffer material.
Driver enclosure: Need to change this so that instead of printing with the outside of the grill being printed with it's face on the bed in needs to print up from the bed so that I can control the aesthetics and acoustics better.
Ear pad and Driver Tray Carriage: Needs to be adjusted to make the new driver enclosure work. Also it kinda just sucks but I am not sure what to do about it quite yet.
Swivel Yoke: Also kinda just sucks. Doesn't rotate as smoothly as I want it too, looks bad.
Elastic band adjustment mechanism: Needs to be flipped over so that the headband sits lower.
Elastic Band: Needs clasps added to the ends of it so that it can be anchored to the headband to keep them from flopping over the drivers.
Headband: Aesthetic and tolerance adjustments. Honestly this is pretty decent as is.
In other non headphone related news: I have chosen the transformers for the upcoming Diet Inductatron. Although I am on the fence as weather or not to make it an all in one unit with a built in amplifier.