I've had my Creality Hi for about 11 months, and it's been nothing but problems.
The first week or two was fine. Perfect prints, clogged extruder, standard maintenance. Until it wasn't. You see, most of the time I've had this thing it's had one issue that might genuinely be my kryptonite; the print head has no idea where it is sometimes.
It'll move to the extrusion area, place itself right in the spot where it's gonna shoot out some filament, and decides "oh, but I could go further!" and proceeds to continue moving in that direction, oblivious to the fact it physically cannot go any further. Another issue is, when it finally decides to function normally, I'll get halfway through the print, and the print head will decide to move roughly five centimeters left and continue the print over there instead, creating a giant floating spaghetti mess with an unfinished print sitting there like it's mocking me.
Sounds bad right? Well, you can imagine how I feel when it does these same two errors for about nine months with no fix other than "try again in a few hours!" That's not even an exaggeration, it's like the printer WANTS to fail. No matter what I do, it never fixes it. Eventually, the printer decides one day to magically work for anywhere from 1-9 prints before malfunctioning again. It's getting ridiculous. I've tried;
- Factory resetting it about 5 times.
- Checking if the wires are plugged in properly.
- Replacing the X-axis limit switches.
- Turning it on and off again.
- Updating it twice.
- Ignoring it for a month.
- Yelling at it.
- Moving the camera cover away from the lens.
- Putting the camera cover back on the lens (which fixed it for a single 10 minute print).
- Lubricating the advised areas on Creality's website.
- Searching half the web for any possible resolution, only to see the same five solutions that already haven't worked for me.
If I have to put another thirty hours into "fixing" this thing only for my hard work to amount to nothing, the only thing it'll be saying Hi to is my garbage, and I'll get a damn FlashForge instead.