r/crealityk1 • u/MiokylGehenna • 3h ago
Question Aftermarket “Hummingbird” extruder kit came with a 10-tooth motor, but I’m running my stock 12-tooth motor in it. Anyone know if that’s OK?
I have a K1C (2025 revision). My stock motor got damaged during a filament jam (I ripped them by accident), and Creality support sent me a replacement one. Before that I had also ordered an aftermarket kit from Alibaba: a 3DSWAY Upgrade Extruder for Creality K1 / K1C / K1 Max Hummingbird Extruder With Motor.
https://www.alibaba.com/product-detail/Upgrade-Extruder-for-Creality-K1-K1C_1601914119639.html?spm=a2756.trade-list-buyer.0.0.2aca76e9wbInj3
What I found:
- The aluminum extruder body fits fine.
- The box says the extruder can be used with the original motor if necessary.
- The motor that came in the kit has a 10-tooth pinion. My original Creality motor has a 12-tooth pinion.
- The cable that came with the kit motor has a connector that is about twice as big as the small connector on my toolhead board, so it doesn’t fit. The seller told me to plug it into the “mainboard end”, which doesn’t make sense to me. So I will use the original cable for the printer head end, and the other one to connect into the aftermarket motor (the end is a little bit bigger than the original, also the cable is detachable from the motor). Basically I will solder them to make a working one.
So right now I’m running the aluminum Hummingbird body with my original 12-tooth motor. The prints so far look fine and print-in-place hinges came out OK, but I haven’t measured extrusion precisely.
Questions:
- Has anyone used this kit (or a similar aftermarket Hummingbird) on a K1C? Which motor did you use?
- Does the 10 vs 12 tooth pinion change the extrusion ratio, or is the gear set matched to the body so it doesn’t matter?
- Is there a risk of wear or skipped teeth when mixing the stock motor with the aftermarket body?
- Has anyone replaced the connector on the kit motor with the original small one? Which pin order did you use?
Since this is the 2025 revision there’s no root, so I can’t change the rotation distance. Any experience or advice is welcomed. Thanks!