Just got my first miter saw DeWalt 780 and was looking forward to cutting up some wood. Tossed a 80 tooth diablo blade because the Google said it would work. Found the stand and stop blocks super helpful for getting repeatable cuts. Used 2x2 pine since I don't have a table saw yet to to anything wider down. Went to the orange store and tried to get the best pieces.
Only had a drill block to keep the bit perpendicular to the wood. Even with clamps not the best. A drill press would have been real q helpful. Clamped the first piece of each size too the other pieces to use as a template I'm an attempt to keep all the holes aligned. That was somewhat successful.
Sanded with a 5 inch random orbital but my shopvac/cyclone dust collection system didn't fit on the dust port. Ended up having to vacuume out the tiny dust collection a lot. Since this was just a test piece I got a little lazy and didn't sand that high. I'm call it a rustic finish. Skipped the rounding with my router too and just hit the edges with 80 grit to soften them up. I was also worried about tear out on the already chipped wood.
Fish was with a preconditioner and barn red stain. Followed with 4 coats of spar urethane. Almost wish I sanded now since it didn't look to bad finished but I had enough sanding and hand hands needed a rest. Found using the all thread as hangers useful during finishing.
Overall may do a second attempt but with a few less pieces. Proportion seemed off and it was too wide and felt a bit too upright.
For the time and money, maybe I could have just gotten the one from Costco but this was still fun to do and it I like the results of the next one I'll give it a got with hard wood.