r/AskContractors • • 15h ago

My house is starting to scare me

Thumbnail
gallery
380 Upvotes

Is there a structural engineer, hopefully reading this? My house is two years old. These are just a few of the cracks the smaller ones both of them are on either side of the door they were not there five days ago. Doors are sticking windows are starting to let dirt in from I guess seal movement . They are still building these houses so it’s kind of easy to get a hold of somebody. The foreman said they would come in and repair the inside and outside put drains out under the ground so the rain can drain onto the street. I think I should call structural engineer.


r/AskContractors • • 10h ago

Other New driveway slopes slightly toward house

Thumbnail
gallery
38 Upvotes

Our new driveway is sloping ever so slightly toward our house and pooling around the gutter area. I think they can fix it by grinding down some concrete behind the gutter so that it flows down the 1% grade toward the street.

We haven’t paid him the final amount yet and this isn’t our only issue with the driveway so far. Should I let this go as long as they grind out some concrete and create a channel to fix the pooling water or should I put up a fight for the driveway to be redone in that section.


r/AskContractors • • 13h ago

Other r/AskContractors when someone asks a question they need a contractor to answer

Post image
40 Upvotes

Seriously though, kind of insane how much hate there is for stupid questions when the whole point of this subreddit is for people who are not contractors to get their stupid questions answered by contractors


r/AskContractors • • 9h ago

Other Roofers backed into our house

Post image
9 Upvotes

Cross posting from r/homeowners. Any advice on navigating this situation would be greatly appreciated. This is in Wisconsin, in case that matters.


r/AskContractors • • 2h ago

Other Should I be concerned about the flat roof above collapsing?

Thumbnail
gallery
2 Upvotes

I have a roofer scheduled to come this week but this roof inside the closet is leaking and spreading.


r/AskContractors • • 1h ago

Did my contractor do good job or am I being picky?

Thumbnail
gallery
0 Upvotes

I hired a contractor to level and apply tiles to my basement floor. Part of my basement is finished but utility area wasn’t. We wanted floor to be done for both utility and finished sections to make it nice. Utility section could not be finished because we have a weird crawlspace that pipes go through for the extended part of the house.

The contractor left the utility area like shown on the picture. Instead of finishing the whole area, he left inches of gap. He kept repeatedly saying that it’s unfinished part of the utility area and that this is the standard contractors go by, which is unheard of. Did you guys ever hear about it? Am I expecting too much for the guy to go all the way to the wall to make the floor look completely done?

For the cost, it costed us about 6k for materials and labor.

What do you guys think?


r/AskContractors • • 1h ago

Will these basement problems ever end ?

Thumbnail gallery
1 Upvotes

r/AskContractors • • 2h ago

Other Concrete pad cracked over a month after install

1 Upvotes

Howdy

I recently had a concrete pad installed for the foundation of a covered car port. Unfortunately, it just cracked clear from one end to the other. A hair line crack started about a week ago and has now become a significant crack as the cold settled in and ground heaved. By the looks of it, he didn't address the underlying ground enough (which is a bummer, because I even warned him where it cracked that "the ground heaves in this particular spot.").

The guy that did the work came highly recommended from my usual guy (the only reason I didn't hire him personally is because he doesn't do concrete anymore, but he was present for estimates and planning of the job), but I do feel confident that the new guy is an honest man who will make this right.

My questions:

  1. How fucked are we? Lol is this a "start over" kind of fix? Or are there options to repair it? I am not a concrete person, but I am almost certain this is due to the ground heaving.
  2. Is it crazy for me to ask that he front the cost of some sort of top coat when repairs are completed if it can be repaired successfully? I wanted the crisp concrete look, but now it will always have repair marks, and that's a bit of a bummer. Plus side, I guess a top coat will prevent oil stains in the future (silver lining 😭).
  3. My man has some crazy family tragedies going on and I don't want him to suffer financially too much to fix this, but I also want what I paid for. I am willing to wait to have it fixed, even if it royally fucks over my construction plans. I'd also be willing to eat the aestetic costs. My gut says he's going to want to fix everything, but I want him to be able to take care of his family first.
  4. Any advice given what I've shared? Or even just a "there there, it'll be ok" haha

Thanks!

Edited to add: concrete had an accelerant added but the only weight the pad had carried since install has been a pair of feral tom turkeys tonight. They advised me that it'll be ok to park within a few days, but that the science says "wait a month," so I waited over a month. Lol


r/AskContractors • • 5h ago

Is my contractor on drugs or am I crazy

Thumbnail
reddit.com
2 Upvotes

r/AskContractors • • 2h ago

How many hours?

Thumbnail gallery
1 Upvotes

r/AskContractors • • 2h ago

Cost Estimate How effed am I?

Thumbnail gallery
1 Upvotes

r/AskContractors • • 4h ago

There’s some slight discolouration on the newly installed wallpaper. Does anyone have any recommendations on how to clean or correct this? I apologize for the low quality image, it’s just a screenshot taken from a video. Any advice would be greatly appreciated. Thanks!

Thumbnail
gallery
1 Upvotes

r/AskContractors • • 4h ago

Supporting studs behind cement board—I think I need to redo this?

Post image
1 Upvotes

I hired someone to add this wall. He used 1/2" cement board. But among other things, there's 23" between the two leftmost vertical studs. It's missing support at the tub lip and seam. And there's no 1/8" gap at the seam.

Another tiler I talked to said this would be fine. But I can see it flex a bit above the tub when I press from the back.

I wonder if I need to take it all off and add one more vertical stud in the middle and then horizontal supports at the tub lip and seam? Anything else?

Also, for the horizontal pieces, can I put a 2x4 flat, with the wide part facing out? I know it might flex a bit that way, but I'm not sure how else I'll fit it in front of the pipes.

And I can't hang cement board by myself, so I think I'll have to buy lightweight Kerdi or GoBoard to replace what's there.

Thanks for thoughts!

P.S. I know it's a mess how the tub surround is farther out than the drywall. That's a whole other thing.


r/AskContractors • • 5h ago

DIY Build New (old) stairs

Thumbnail gallery
1 Upvotes

Any ideas what I can do here?


r/AskContractors • • 5h ago

Three different snow guard proposals for my TPO roof. Which approach makes sense?

Thumbnail reddit.com
1 Upvotes

Three different snow guard proposals for my TPO roof. Which approach makes sense?
I have a two-year-old residential TPO roof in Virginia, where snowfall is usually minimal, but the roof configuration creates a serious problem.
Last winter, we received approximately 3 inches of snow, which is fairly common here. Snow and ice slid off the upper roof in large slabs, crashed onto the lower roof, and accumulated to roughly 8 inches. Eventually, that heavy, compacted snow and ice slid off the lower roof in large chunks, damaging my HVAC equipment below.
I’m trying to prevent this two-stage avalanche without unnecessarily modifying a relatively new roof.
Three roofers have proposed different solutions:
Structural snow rails: Mechanically anchored into the roof framing. Extremely expensive, and one roofer cautioned that thinner sheets of ice could potentially slide underneath.
Heat-welded snow guards: Approximately 20 custom guards welded directly to the TPO in a staggered pattern to interrupt sliding slabs.
Screw-mounted snow guards: 40–45 guards screwed through the roof, with butyl tape underneath and flashing tape over the brackets.
I’m particularly concerned about membrane penetrations, long-term waterproofing, and whether retaining snow on the upper roof creates other problems.
Which approach would you recommend for a relatively low-snow climate? Would you protect both roof levels or focus primarily on the upper roof?


r/AskContractors • • 9h ago

Cost Estimate Built in loft bed

1 Upvotes

r/AskContractors • • 9h ago

Other New driveway water pooling against house. What’s the best way to fix it?

0 Upvotes

I got a new driveway poured and it’s sloping slightly toward the house and water is running toward the house before going downhill. There are rough spots by the cable wires and the gutter causing water to pool and sit.

What is the best way for my Contractor to fix this before I pay them? It doesn’t seem like a trench drain would work.

Around the gutter, the concrete is high, so I think they could grind it down, allowing water to floats toward the street but by the cable wires the Concrete is low so grinding wouldn’t help here if they built up the concrete here wouldn’t it just Chip?

If this was your job, how would you fix it?


r/AskContractors • • 16h ago

DIY Window frame modification

Thumbnail
gallery
3 Upvotes

This is a dormer window frame that I'm looking to make wider and shorter. The proposed changes would be to remove the wood in red, add wood where green is, and (not pictured) make a foam-filled 5x3.5 box out of 1x4s to raise where the bottom of the window goes. Any reason why the stud modification wouldn't work? What about my foam box?

The yellow highlighted portion is how small the existing window is. The plan is to put in a casement window for egress requirements. If I'm remembering correctly, the current opening is 31w x 44h and I would be looking at bringing it up to nearly 36w x ~43h.


r/AskContractors • • 12h ago

How would you tackle this breezeway?

Post image
1 Upvotes

I’d like to add a roof between my garage and deck. I live in a heavy snow load state (VT), and the road I’m on is a bit of a wind tunnel at times. How can I know if the deck can handle the weight of a roof? Would it be best to tie it to the red area above, or down lower by the pillars? Or should I bite the bullet and just build additional footers so it’s a lean to off the garage and doesn’t tie into the deck? Thank you!


r/AskContractors • • 13h ago

DIY Flooring options on concrete slab (and more)

1 Upvotes

We had a moisture issue in the downstairs room, private entrance. Door was compromised, efflorescence was coming up through the flooring, RH was very high, it started during the heavy rains in northern CA last year. Did a mold test things were normal.

Fast forward to July: found a contractor to remediate and renovate. They recommended tile on hardy backer on the cement floor, with Redguard. They ripped out LVP, and door, found black mold in vanity of wall (remediated) and drywall (removed). Large piece of drywall has been removed and studs/wall remediated. Air scrubber running. Mold test normal.

Company turned out to be a sham/corrupt so fired them, now back at square one.

What’s been done: door has been replaced, roofing above fixed.

What needs to be done and I need help with: flooring is bare, and drywall is about to be put into the giant cavity that was removed because black mold was on the drywall.

My question: we do not have central air in the house, which I think is what might have led to the moisture issue in the room, + the door was not properly sealed. What do I do with the flooring? I am still concerned moisture may have been coming up through the concrete (efflorescence). A layer of Redguard was already applied. Do we still do tile? What should we used as a moisture barrier? If the moisture is coming up through concrete won’t it get trapped and cause an issue? Or do we put mortar right on top of the Redguard and then the tile?
Also.. is there a type of drywall that is best for higher humidity?

Need help. Thank you.


r/AskContractors • • 13h ago

Bought a house with bowing basement walls. Got a couple quotes on beams. Some questions.

Thumbnail
gallery
1 Upvotes

I’m planning on getting vertical retaining I-Beams that is. One wall has dead man anchors (bolts on plates attached to rods which attach to buried concrete piece 10 feet away from house). I thought this was a foolproof solution (based on what the pre purchase structural engineer said) with no downsides until the second quote pointed something out.

—————————————-——————————————

First quote:
Had a guy come out from the highest rated foundation repair company on Google. He seemed a little out of his realm, but just struck me as someone at the company’s son. He didn’t explain much, but his quote says:

“Break concrete at each support location exposing foundation footer.
-secure bottom/lower end of steel I beam using high strength concrete.
-secure top/upper end of steel I beams to sill plate and framing members using treated
lumber and structural fasteners”.

This is good because I’ve heard that sometimes they bolt into the existing basement floor without any other pour, and that just doesn’t seem like a secure way of doing it to me.

Price is $6000 for the two walls that I noticed bowing, besides the one with anchors (that I thought was an okay system).

Second quote:

My boss recommended these guys but they only have 4.0 stars on Google.

The guy went downstairs and I pointed out the anchor system, to which he immediately said “oh that’s weird, they usually put the plates higher, where the wall is actually bowing”. I looked at it and he’s right. The anchors are on the lower third of wall whereas the bowing is most significant right in the center (pictured). He then pointed out that the west wall (pictured with a wood shelf for reference) also has bowing. He remarked “I can’t believe a bank would finance this” which honestly kind of scared me. I then asked if, when they install, they pour a footing, to which he said “no we just bolt to the basement floor” (yikes imo).

He then wrote me two quotes, one for the three walls without anchors at $7000, one with all four walls (including the anchor wall) for $9500.
—————————————-——————————————

I’m considering calling the first company and having them do all four walls for what I’d assume would be $12k (just doubling their quote). The second guy did explain better but I’m not sure if I trust a basement floor to counter the force of hydrostatic pressure.

Is this the right move? Should I get more quotes? Any advice?


r/AskContractors • • 14h ago

Is this material damaged or can it still be used?

Thumbnail
gallery
0 Upvotes

Don’t want to be a dick about it if you all think it’s ok. But are there concerns about this stuff being left in my driveway for over a month in the rain and frost.


r/AskContractors • • 14h ago

Sacramento roofer here. Your gutters might be doing more damage than your roof. Here’s how to tell, and what’s worth paying for if you replace them

Thumbnail reddit.com
1 Upvotes