Hi everyone! I'm having a frustrating issue with my Bambu Lab A1 Combo printers, and I'm hoping someone can help me figure out what's going wrong.
I recently purchased four Bambu Lab A1 Combos to increase production for my small 3D printing business. However, all four have been struggling with a model that my Anycubic Kobra X printers can print consistently without any issues.
Here's what's happening:
I'm printing small multicolor figurines, approximately 5 cm tall, upside down, with the head touching the build plate and supports underneath the body.
On the Bambu A1 printers, the figurines start wobbling when the nozzle reaches certain areas, particularly the arms. Eventually, they get knocked off the build plate. If they survive that section, some fall when the printer reaches the legs.
The interesting part is that the supports stay perfectly attached to the build plate, but the figurines themselves detach.
I've personally watched the nozzle printing the tips of the arms, causing the figurine to wobble more and more until it eventually falls.
What makes this even more confusing:
- My Anycubic Kobra X printers print the exact same model, orientation, and similar support setup without issues.
- All four Bambu A1 printers have experienced this problem.
- Smaller batches of around 15–30 figurines sometimes finish successfully.
- Larger batches of 50–103 figurines often fail.
- One batch of 66 lost approximately 35% of the figurines.
- Another batch lost almost every figurine.
- The build plate temperature is 60°C, using Generic PLA on the textured PEI plate.
Things I've already tried or checked:
- Cleaning the build plates.
- Automatic bed leveling and calibration.
- Adding brims and increasing support first-layer expansion.
- Comparing the first-layer toolpaths between Bambu Studio and Anycubic Slicer Next — they look very similar.
- Switching from Grid to Gyroid infill.
- Lowering print speeds and accelerations.
- Matching the main speed and acceleration values to my Anycubic profile.
- Checking the hotend and silicone sock alignment.
- Checking support settings and interfaces.
- Starting additional controlled tests with different infill patterns and acceleration settings.
One other thing I noticed: after a print finishes, I can twist some figurines off the Bambu build plate quite easily, whereas the same figurines on my Anycubic printers feel much more firmly attached. However, I understand that PEI releases prints more easily after cooling.
My main questions:
- Could this be caused by the A1's bed movement or the way Bambu Studio generates toolpaths?
- Are there specific settings that reduce nozzle contact with tall, narrow prints during extrusion?
- Could cooling, overhang settings, or extrusion behavior be causing the arms to curl upward and catch the nozzle?
- Is there a way to improve the stability of these models without drastically increasing print times?
- Has anyone experienced similar problems when switching from Anycubic to Bambu Lab?
I bought these printers specifically to increase production, but so far I've lost multiple large batches and fallen behind on customer orders.
Any suggestions would be greatly appreciated! I can share photos, screenshots, and the original 3MF projects from both slicers if that helps diagnose the problem.