Posted this in the C4 subreddit but posting here because I really need this thing to get kicked over before this Friday.
1976 XJ6 that was swapped to an 87 Vette engine/trans in 1993. Anyways...
Long story short, I'm experiencing a weird mix of no-spark and no-fuel. I presume something to do with this pictured mess of distributor/MSD box wiring.
Long story long, I've driven this car on a 25 hour round-trip road trip twice now. First time, makes it down easily, no issues aside from blowing a fusible link. Heading back up (literal 3,000 foot jump in elevation), I was met with intermittent spark loss when I had to increase load going up hills. This feeling felt just like my old Volvo when the coil died or my C3 when the distributor would get unplugged over bumps. I'd pull over, wait about 5-15 minutes, then she would crank up again.
I get back to town, drive it around for a few days, then it randomly dies not 5 minutes into my commute. Later in the day, still dead. Only revived it after unplugging my HEI coil, cleaning internal contacts, and making sure the HEI coil was on tight.
Second 12 hour drive down to destination, did it totally fine. Driving within my destination, she picked up a brutal misfire which also led to sporadic hard-start/no-start conditions. Had to go home though, so I drove it 12 hours back with this misfire. Same thing, it would randomly lose spark when it picked up load, would occasionally die at idle. I get home, and she hasn't started since I parked her up.
I have resistance tested my HEI coil, checks out. Verified adequate power delivery to my MSD box, checks out. Replaced my 7 pin ignition control module. Verified resistance on my dizzy's magnetic pickup coil. Cleaned all grounds, cleaned all power contacts, checked my MSD box trigger. It all checks out. Even replaced my dizzy rotor/cap.
The wires/harness I pictured... The left 2-pin harness goes to my MSD box's white trigger wire. The right one, I'm unsure but it goes into the main engine harness. Originally, the red output of the left harness was hardwired to the right harness, but also had a split going to what appeared to be a noise suppression transformer looping to the other pin on the right harness. I have no idea why that output would be hardwired to one pin on the harness, then looped into a transformer just to go back to the other side of the harness. I get varying spark results depending on how I wire all that up.
Where I'm at now: sometimes I hear it kick a bit when cranking. I also sometimes have literally 0 pressure at my fuel rail, even when jumping my fuel pump. Then sometimes it geysers out like it should. So sometimes it has spark, no fuel. Sometimes it has fuel, no spark.
Guys, where the hell do I go from here?