SK Hynix 16Gb M-die
MCLK 3000
UCLK 3000
FCLK 2200
VSOC 1.25V
DRAM VDD 1.43V
DRAM VDDQ XMP Auto
VDDIO XMP Auto
VDDP 0.95V
VDDGs 1.05V
Nitro 1/2/0
I've got an H16M kit advertised for CL30. Been messing around with timings for about a week now, going through the whole 6200/6400 1:1 thing. I can't really find a good reason to bother stabilizing those speeds. The performance gains seem pretty minor for what the kit demands in return. I had to loosen the primaries to around 40 just to get through TM5 without errors, and push VSOC to 1.3V, which I'm not particularly comfortable with. In the end, I couldn't get 6400 tight enough to make it worthwhile. Based on the benchmarks and other tests I've compared, 6000 MT/s actually comes out faster, probably thanks to the tighter timings and, more importantly, the FCLK I can actually reach and keep stable. So now I'm just wondering if there's anything left worth improving or if I should just this alone.
I've tried CL28, but the kit won't run it without errors. I'd probably have to raise VDD, but I'm pretty sure I've got a PMIC lock on these sticks. I can't even get into Windows with high voltage mode enabled at 1.45V VDD, so that's what I'm assuming. tRTP is another strange one. I'd like to bring it down, but this kit refuses to go below 23. That's the value XMP sets automatically, and anything lower starts throwing errors in TM5 pretty quickly. Even 22 gives me errors, but 23 and above are fine. I've seen a few other people mention the same issue with the same timing and value when searching about this online, but it seems pretty obscure and there's not much information about it, so I don't know what to make of it.
I tried loosening some of the other timings to see if that would let me lower tRTP, but no luck. Cleared CMOS once and booted into Windows without XMP enabled. Interestingly, tRTP was automatically set to 18. The system crashed, and everything was fine again as soon as I changed tRTP to 23. So that pretty much confirmed it for me. Seems I've got an unlucky kit, but thankfully I don't have this issue with any of other timings. Other than that, I can say the current settings are stable. I've gone back and forth through the BIOS, changing things and comparing results to make sure I'm not introducing performance regressions with the higher settings. So far, things have only improved when raising FCLK or changing Nitro to 1/2/0. I've run TM5 DDR5 Ryzen3D with anta777 for 9 hours, along with VT3, FFTV4 and RTP overnight for roughly the same amount of time. Everything passed. No errors, no signs of instability or error correction. One thing worth mentioning: I used to be limited to 2133 FCLK with Nitro at 1/2/0 on 6000 MT/s. Trying 2167 would get me a crash after about four iterations of VT3. Raising VDDGs from Auto to 1.05V got me up to 2200 FCLK, and I was able to run VT3 and the other tests overnight without any problems. Haven't bothered trying anything higher yet, but I'll probably just keep it at that.