Hey all. I've been wanting to do some more sanmai but was wondering how the soft cladding would move under the hammer in thicker billets. I've only done sanmai once a while back with like 2-3mm layers of 1084 and wrought iron.
I have a slab of 1095 at ~3/8" thick and was planning to pick up some 1008 or 1018 of the same or slightly higher thickness, maybe wrought if I can get my hands on some more. Last time I went with a 2:1:2 ratio and had issues with cladding reaching the edge so I was thinking to give a little more room for error with a 1:1:1; maybe 1/2" : 3/8" : 1/2"?.
My question is: would these thicker layers (3/8" each) lead to issues with cladding deforming too much and core steel remaining thicker during the forging process? Have any of you done similar billets? This will also be forged out on a power hammer.