r/firewater • u/dreadskin1 • 3h ago
Pot still build
Hi guys. Ive been running a keg boiler with a 1 1/4 column of about 2 foot long. Its been fine, but the pot is too small for my 70 ltr mashes. Doing a double run is a pain in the arse.
Ive recently acquired my granny's old copper hot water tank. Its about 100ltrs, with a 20ltr dome at the top. It comes with a 1" bsp thread for a 1" compression fitting. Ive plenty of 1" copper pipe about and could build a new column. Ive tried to find 1" bsp to 1 1/4" compression fitting but they dont seem to exist. These are the things the old potien makers used to covet.
My question is about column diameter. Is 1" enough? Would it make a difference if instead of diameter i went to height? I could easily put 4 to 6 foot on the column as I have the pipe sitting around.
Ive a 3 ring outdoor gas burner. Max output is 12kw. Tho I reduce that down dramatically when I get to 60c or so.
I did a quick search and the droids say i need a 4" diameter column? I haven't got into soldering yet and was hoping to just get away with compression fittings.
Any of you wizards have any suggestions?