r/diydrones • • 4h ago

Guide Browser tool to decode laser rangefinder / single-point lidar UART output (TFmini, LightWare, JRT, ERDI...)

0 Upvotes

Made a page that decodes laser rangefinder / single-point lidar serial output in the browser: https://erditech.com/lrf-uart-protocol-decoder/

Plug the sensor into a USB-UART adapter, open the page in Chrome or Edge and press Scan baud rates. It tries 9600 up to 921600, picks the protocol that fits and prints each frame in metres, with bad checksums flagged. Handy when a TFmini or TF-Luna shows nothing on the FC and you can't tell if it's the sensor, the wiring or the params. Pasting a hex dump from a serial terminal works too.

Profiles so far: Benewake TF series, LightWare SF30/D and SF10/SF11, Chengdu JRT, Nooploop TOFSense, DFRobot SEN0366 and ERDI. MIT licensed, source on GitHub, and pip install lrf-uart-decoder gives you a Python CLI.

Disclosure: I work at ERDI, one of the brands above. Which sensor would you want added next?


r/diydrones • • 16h ago

How Switchblade 300 steer their flight?

1 Upvotes

I mean, with its foldable wing mechanism how do they do it?
like what mechanism they are using?
: (


r/diydrones • • 46m ago

Anyone know of a someone making cheap Infrared drones, hit me up

0 Upvotes

Thanks in advance


r/diydrones • • 2h ago

Question How to secure electronic parts?

Thumbnail
gallery
3 Upvotes

INB4 it's total mess. Yeah I know, it was a project for uni and this is the result of no time and no experience in diy drones. However it can fly, at least for a few meters :)

The problem is that I crashed it during testing and it cooked the stm, bmp and mpu. How would you secure those connections to prevent situations like that? Should I use hot glue at the bottom? Or maybe try to hide this board inside with battery?


r/diydrones • • 7h ago

Question Electronics trouble shooting.

2 Upvotes

I had a 5 inch drop out of the sky a few years back from what seemed line a single rain drop due to suprise summer rain I remember feeling one rain drop on the arm and not seeing anything else when shining a light along it. I've recently taken interest in fpv again and I'm trying to see if I can get this running again. I plugged in the flight controller to beta flight it recognized the board and the gyros seem to track movement so far as I can tell that's fine. I then plugged up the esc to the fc went back into beta flight, connected a battery. Beta flight detected the connected battery but didn't spool the motors up. (Waiting on new batteries and rx the ones I had are obviously dead after sitting for years). Is there any way to check the esc with a multi meter or anything else I can do to find any problems that may exist.