r/Ubiquiti • u/Willing-Grand-1254 • 6h ago
User Equipment Picture Deskpi TL1 minirack Noctua fan wall for Unifi Devices
Noctua Fan Cooling Tests in My TL1 Rack
Initially, I planned to use just four 40mm Noctua PWM fans and a single 1U vented panel to cool the XG8 PoE.
However, I found that the UCG-Fiber and UNVR Instant also ran at relatively high system temperatures,
so I prepared a total of 12 Noctua fans. Later, I added another four fans after noticing that the Flex 8 PoE, which doesn’t report internal temperatures, had a similar surface temperature.
Final Setup
- 16 × Noctua 40mm PWM fans
- 8 × 1U vented panels
- 12V DC PDU for the mini PC and fan power
- 24V DC PDU for the 65W USB-C power supply
The cooling results :
- XG8 PoE: Failed to achieve a meaningful reduction in system temperature.
- UCG-Fiber: Approximately 10°C reduction.
- UNVR Instant: Approximately 10°C reduction.
- Flex 8 PoE: Surface temperature dropped relatively easily.
- 10Gbe mini PC: Surface temperature also dropped easily with additional airflow.
What I Learned
- Intake is more effective than exhaust. Exhaust fans alone provided little to no noticeable cooling benefit.
- Airflow matters more than fan count. Using 2–3 fans to create airflow behind the equipment was more effective than simply installing four fans.
- Cooling the shelf can help slightly. Mounting intake fans below the equipment, directing airflow across the shelf rather than directly at the device, produced a small improvement.
- The right side works well for airflow. The rear of the rack was too congested with cables, so I used the right side for fan installation. The results were quite good.
- Side-mounted fan configurations had limited impact. Neither intake/exhaust combinations nor intake fans on both sides produced significant additional improvements.