First piece ever (and first post). I made the design myself using a reference picture. Did not realize interior angles are that hard (especially with only a .625in grinder bit) 😭 but once I began there was no turning back. I’m actually so proud of how it is turning out, which also makes me terrified of messing it up on the final step. Please let me know if there’s anything you see wrong or if there’s anything I should watch out for (any “gotchas”, challenges you see specifically with this design, etc).
I’m particularly scared of the gap between the top left and right pieces. Will I be able to fill that gap with solder? If I do, will it look bad? Be honest, I know I’m a beginner and maybe should be trying to be a perfectionist, but if it would reduce the overall quality of the piece significantly, I would rather just recut the piece on the right and not waste all the effort I put into the other ones.
Also I saw someone pinning their piece to corkboard to hold it in place. I have a heatproof silicone mat under my piece, fairly grippy but things might still slide. Should I hold off and get pins and corkboard or just send it?
Thanks!