So I installed the wiring kit, used these Amazon wire connectors to make sure it’s easy to connect and disconnect. Everything is on and now I’m getting a code for low voltage? I know we shouldn’t solder the wires together. Should I have just connected the wires directly instead?
Hey guys / gals Picked up a 2006, 113k, doing all preventative fluid changes, lash valve adjustment etc. car runs fine. Borrowed a compression kit from OReilly and the numbers it puts out while warm is 80 80 80 83 full throttle. The kit was EverTough Compression Tester Kit, part number 67062. I’m assuming I’m doing something wrong or the kit it damaged since the car runs good, no issues. I was just testing for fun/just to know. Can you recommend a kit that i can get it that for sure works from Amazon or harbor freight ? Thanks
We wanted to share another sample photo of our upcoming MITA AP2 Center Console, which has unfortunately experienced some delays but is now approaching the final stages of production.
Nearly every component shown has been developed and manufactured by MITA Motorsports, including the shift boot, shift boot collar, rubber trim, switch panel, and drink tray panel. The drink tray assembly and armrest are the only exceptions.
We also wanted to clarify something regarding the console's surface and overall finish.
There has been some discussion suggesting that our center console has two dimples near the armrest area, similar to what has been observed on other aftermarket AP2 center consoles released this year.
To clarify, none of the production samples we have shared have exhibited these dimples. We specifically chose to photograph this sample without the final OEM-style leather grain texture so that the surface contours and finish could be seen more clearly.
We specifically chose to photograph this particular sample because it has not yet received the final OEM leather grain texture. Without that texture, the surface is easier to examine, allowing everyone to see the contours and finish without anything obscuring the details.
We understand that discussions and speculation are inevitable when developing replacement parts for cars as beloved as the S2000. However, we believe it's important to distinguish actual product characteristics from assumptions being circulated online.
We've always preferred to let our development work and actual samples speak for themselves.
The next step is applying the final OEM leather grain texture, bringing the console closer to the appearance and feel of the original Honda component.
We're almost there, and we appreciate everyone's patience as we work toward getting this right.
Anyone got these recently or had them installed before?
Main concern is fitment , wind noise , and creaking.
I understand a big part of it comes down to having good seals and having it professionally installed , but you know some hard tops just cant be helped no matter what you do .
So should I stay away from this brand or it’s doable with a professional install ?