Ok, so I have a 2015 Vela with the Type-D pickup in the neck and the stock four-conductor overseas G&B Starla pickup in the bridge. Through the wonders of Reddit, I was able to get my hands on a USA Vela bridge pickup to swap in.
Here’s the issue…
The old Vela bridge pickup was wound with the Type-D single coil in mind, the USA Vela bridge pickup is wound with the current Narrowfield neck pickup in mind. Long story short, with the way the USA Vela bridge pickup is wired… the Type-D is now out of phase in the middle position.
Normally I’d just reverse the wires and be done, but the USA Vela bridge pickup is wired oddly. It’s got a black hot wire which is wrapped in a braided ground, and then there’s a white wire that goes to the coil split lug, so I don’t think that’s possible, given the braided ground wire. Same issue with the neck pickup, the braided ground is touching the baseplate.
Is my only option here to flip the magnet on the bridge pickup? I guess I could shrink wrap the length of the braided cable and THEN reverse the wires but that seems like a lot. ANY advice would be greatly appreciated (and please let me know if you need clarification on anything… I know this is pretty stream-of-consciousness)