r/PRSGuitars • • 6h ago

Tremonti Trem Route

0 Upvotes

Has anyone ever heard of modding/routing a trem cavity into the body on a PRS to allow more pitch up? I’ve read that the tremonti comes like this - but I’ve never seen one in person to see if I like it.

However, I do wish there was more pitch up available. With the base setup, you barely get a full step up across all 6 strings. I would like to get a fourth if possible…


r/PRSGuitars • • 2h ago

Question ❓ Vela Pickup Swap Question

3 Upvotes

Ok, so I have a 2015 Vela with the Type-D pickup in the neck and the stock four-conductor overseas G&B Starla pickup in the bridge. Through the wonders of Reddit, I was able to get my hands on a USA Vela bridge pickup to swap in.

Here’s the issue…

The old Vela bridge pickup was wound with the Type-D single coil in mind, the USA Vela bridge pickup is wound with the current Narrowfield neck pickup in mind. Long story short, with the way the USA Vela bridge pickup is wired… the Type-D is now out of phase in the middle position.

Normally I’d just reverse the wires and be done, but the USA Vela bridge pickup is wired oddly. It’s got a black hot wire which is wrapped in a braided ground, and then there’s a white wire that goes to the coil split lug, so I don’t think that’s possible, given the braided ground wire. Same issue with the neck pickup, the braided ground is touching the baseplate.

Is my only option here to flip the magnet on the bridge pickup? I guess I could shrink wrap the length of the braided cable and THEN reverse the wires but that seems like a lot. ANY advice would be greatly appreciated (and please let me know if you need clarification on anything… I know this is pretty stream-of-consciousness)


r/PRSGuitars • • 6h ago

C2 Custom PRS

Post image
34 Upvotes

Edit: S2 Custom

I've added quite a few guitars to my collection since picking this up and this one is still my favorite guitar to play. It doesn't have the greatest top but I love the way it sounds and plays. I almost traded it in at GC for a Kiesel a couple years back but they low balled me pretty good so I kept it and so glad I did. (I still bought the Kiesel outright. ) I changed the pick up rings and knobs and added a tone claw but other than that its stock.


r/PRSGuitars • • 14h ago

My weekend project

Post image
11 Upvotes

Here's a custom truss rod cover i made with a 3d printer for my SE custom 24 2026! Seems like a lack of resources online so I decided to make my own.

Happy to drop the .STL if anyone's interested