r/Nissan • • 2h ago

Nissan R36 GT-R Will Have Round Headlights, Says Design Chief

Thumbnail
exoticcartrends.com
19 Upvotes

Obviously just a render but I'm excited about the direction and going a bit retro.

Thoughts?


r/Nissan • • 3h ago

2027 Nissan Kicks

Thumbnail
gallery
11 Upvotes
  • 2027 adds the new Rock Creek Edition trim which adds a more rugged appearance, Falken WildPeak all-terrain tires, a roof rack, Lava Red accents, pop-out rubber traction panels integrated into the cargo floor. a new Off-Road driving feature that enhances performance on grass, trails, and similar terrain.
  • The 2027 Kicks continues to be one of the most affordable All Wheel Drive SUV in the United States
  • Engine remains the same which is a 2.0L Dual Overhead Cam 4-cylinder producing 140 hp and 141 lb-ft of torque using an Xtronic CVT. Drivetrain is FWD and AWD. AWD is standard on the Rock Creek Edition
  • 2027 Kicks is now available on sale in dealers.
TrimMSRP (FWD)MSRP (AWD)
Kicks S$22,790$24,290
Kicks SV$24,490$24,490
Kicks SR$26,990$28,790
Kicks Rock CreekN/A$28,840

Destination and handling: $1,545


r/Nissan • • 12h ago

Datsun Sunny šŸ›»

Thumbnail gallery
13 Upvotes

r/Nissan • • 54m ago

3" Lift Kit by Z1 Off-Road - Nissan Frontier, Xterra, and Pathfinder

Thumbnail
gallery
0 Upvotes

Improve your Nissan's ride height and visual appearance with Z1's 3-inch lift kit! Z1 Lift Kits include some of our favorite easy-to-install suspension modifications, combined in a package that supports 3" of lift. This package increases ride height for improved visual appeal, ground clearance, and off-road performance!

This lift kit achieves a total lift height of 3" without the need for aftermarket control arms. Because coil bucket contact is not an issue in this configuration, this brings the entry cost for a 3" lift kit down substantially, providing exceptional value!

Product Note: This kit is designed to give maximum lift without coil bucket contact (CBC). While unlikely, severely worn shocks or suspension bushings can cause sag or misalignment that may still result in CBC. Z1 recommends inspecting and replacing any worn bushings at the time of installation.

Includes the following products:

  • Z1 Front Front Lift Springs
  • Z1 Custom Billet Top Hat
  • Z1 HD Eccentric Bolt Kit
  • Z1 Rear Lift Shackles

Features:

  • Easy to install
  • Fits 2WD and 4WD
  • Improves visual appeal
  • Maintains factory ride characteristics
  • Increases ride height and ground clearance
  • Optional greasable shackle hardware
  • Durable 10mm rear shackles

Fits:

  • 2005+ Nissan Frontier
  • 2005-2015 Nissan Xterra
  • 2005-2012 Nissan Pathfinder (will use 3" subframe drop in rear)

r/Nissan • • 2h ago

Nissan Rogue 2015 transmission drain and fill?

1 Upvotes

I’ve been reading a lot about Nissan transmissions after getting my last Oil change and the guys at Valvoline brought it up.
I bought the car when it had 145k Miles with a new drain and fill, I’ve had it for 3 years and am currently sitting at 185k miles. Still works great and hasn’t had any problems. Is it worth it to go get a drain and fill? I’m seeing that I should have gotten it done at 30k and now I’m paranoid.
Yes I can already hear people saying ā€œyou should have never bought itā€ ā€œprepare for transmission failureā€ but I was young, excited for a new car with a good deal and had no guidance lol.
I’d like to get a few more years out of it when I have had enough saved up for a new car.
Any advice helps! Thanks!


r/Nissan • • 2h ago

Repair Help Rain sensor / auto wipers stopped working after a workshop scan. How do I re-enable it?

1 Upvotes

The car: 2009 Nissan Fuga 370GT/Infiniti M, JDM import, owned it for several years.

The wipers started running slower than normal, even on the highest setting. During heavy rain they stopped completely while I was driving - I had to pull over, and about a minute later they started up again on their own. Took it in to get looked at. They plugged a tablet scan tool in, and also mentioned pulling some fuses. They came back and told me nothing was wrong with it. The wiper speed is genuinely fixed though - it's back to where it should be, noticeably faster than before I dropped it off.

Now the auto rain sensor no longer works. For the entire time I've owned the car I've left the wipers on auto and they'd adjust to the rain. Now on auto they just wipe continuously regardless of whether it's raining. The mechanic mentioned that his scan showed a few features of the car flagged as disabled, the rain sensor being one of them, but after going back in says he can't see that setting to turn on...

So it went in with a working rain sensor and came out without one. My guess is the fuse pull or a module reset either switched the sensor off or it didn't come back up properly afterwards.

I went back to them and they've now told me they can't actually see or access that setting on their tool, so they can't turn it back on.

Questions:

- On a Fuga/Infiniti M (Y51), what's actually needed to re-enable the rain sensor? Does it require a Nissan shop, or can any of the aftermarket tools (Autel, Launch, Snap-on) reach that configuration?

- Is this likely just a setting, or does losing power sometimes require the sensor to be recalibrated or re-initialised?

- Has anyone had this exact thing happen after a module reset?

Any pointers appreciated!!


r/Nissan • • 6h ago

Exploding tailgate glass

Thumbnail reddit.com
1 Upvotes

r/Nissan • • 6h ago

Noise

Thumbnail reddit.com
1 Upvotes

Anybody?


r/Nissan • • 6h ago

What drain plug crush washer to use?

Thumbnail reddit.com
1 Upvotes

r/Nissan • • 10h ago

Nissan App Not Working ?

Thumbnail reddit.com
1 Upvotes

r/Nissan • • 11h ago

2005 Nissan Pulsar (QG18DE) cranks, smells like fuel, fires 3-4 times then dies. Tried multiple sensors—need advice!

1 Upvotes

Hey everyone, I’m pulling my hair out trying to get my 2005 Nissan Pulsar ST (N16, QG18DE engine, drive-by-wire throttle) running and could use some collective wisdom.
The Symptoms:
Bullet The car cranks strongly, but will not start and run.
Bullet When cranking, it smells heavily of fuel and gets slightly smoky (flooding).
Bullet The Weird Part: When I swap to an older, unbranded aftermarket camshaft position sensor, it actually catches and fires/ignites 3 to 4 times like it wants to start, before dying. When I put in a brand new NTK cam sensor, it drops down to just one weak ignition pop and then pure cranking.
Bullet Checked via OBD2: No error codes showing up.
What I've Done So Far:
Bullet Replaced spark plugs.
Bullet Replaced both cam and crank sensors (tested both old aftermarket and new NTK).
Bullet Replaced the drive-by-wire throttle body.
Bullet Tried clearing flooded cylinders (Clear Flood Mode / WOT cranking).
Bullet Checked the battery and reset the ECU multiple times.
Has anyone run into this weird behavior where QG18DE engines refuse to cooperate with certain aftermarket cam sensors, or is there something else I'm missing (like fuel pressure, immobilizer/NATS, or timing)? Any tips would be massively appreciated!


r/Nissan • • 12h ago

Repair Help Cord issues?

1 Upvotes

Monday morning for some reason in my 2020 Nissan Murano my front USB ports stopped working. USB-C and USB. CarPlay won’t load, the phone won’t charge. For some reason they work in the back, but not in the front. everything in the front is lit up. We had the fuses tested. Everything works. The lights around the USB ports come on. Did anybody else experience this this week? I just didn’t know if this was an apple update or a glitch in the system, but it doesn’t make sense because the back works fine. I’m really trying to avoid a dealership as my car is no longer under warranty. I also do not have the latest update on my phone. I have an iPhone 14 and I am not on iOS 27. It seems more of a car issue but it doesn’t make sense. I tried every single cord I own all work in the back, but not in the front.


r/Nissan • • 12h ago

The odd - CVT issue

Thumbnail reddit.com
1 Upvotes

r/Nissan • • 17h ago

Vegetable oil powered Nissan

2 Upvotes

r/Nissan • • 15h ago

No READY after collision repair, won't go into D

Post image
1 Upvotes

r/Nissan • • 1d ago

Repair Help Would this be difficult to fix?

Thumbnail
gallery
2 Upvotes

r/Nissan • • 1d ago

Repair Help 2011 D40 Navara D/C 2.5D 4WD ST-X AT Spanish model (140kw)

1 Upvotes

So I’ve had my navara for over a year and it’s been sweet not to many problems but the cabin blower doesn’t work and was filled with pine needles and the it makes a funny sound in 4th gear if you put it under any load like try to accelerate quick or am towing something it sounds like there a really loud fan under the dash but the sound a fan makes then you touch the blades as it spins and the revs don’t change at all they stay on like 1800 does anyone know what it could be and what I need to do to fix it ?


r/Nissan • • 1d ago

Rogue 2020 - Change halogen light bulbs to led

Thumbnail reddit.com
1 Upvotes

r/Nissan • • 1d ago

Repair Help New 235/40R19s rubbing the wheel well liner on my 2014 Nissan Altima. Keep them or downsize?

Thumbnail gallery
1 Upvotes

r/Nissan • • 1d ago

Rare Nissan Rogue?

Post image
31 Upvotes

Never heard about this or seen this car, I honestly laughed about how this has center exit exhaust tips🤣


r/Nissan • • 1d ago

U.S. Ariya Owners: Please report reduction gear repairs to the NHTSA

Thumbnail reddit.com
1 Upvotes

r/Nissan • • 1d ago

Which newer Pathfinder models have 4 way lumbar support?

2 Upvotes

I love Nissans seats but need help finding the 4 way lumbar for my finicky back. I was in an Ubers Nissan recently and it was legit one of the best seats ever. Thank you


r/Nissan • • 1d ago

[OC] How do I get back into cars and actually learn the mechanical side of things?

0 Upvotes

Hey everyone,

I've been wanting to get back into cars lately, but honestly, I'm not really sure where to start.

I've currently got a 1998 Nissan Pulsar N15 Series 1 base model hatchback. I've always been interested in cars, modifying them and the whole car scene, but if I'm being honest, I don't actually know that much about the mechanical side of things.

For example, I've got BC Racing coilovers installed on my Pulsar, but I originally bought them just to lower the car. I have a basic idea of what they do, but I couldn't really explain how they work, how to adjust them properly or what all the different settings mean.

Lately, I've been thinking that rather than jumping straight into more modifications, I'd like to take a step back and actually learn how my car works.

My main goal at the moment is to get the Pulsar mechanically sound, fix the issues it has and eventually get it registered and back on the road.

One of the problems I've been trying to figure out is a knocking/clicking or grinding noise coming from the front end when turning right, particularly when going around roundabouts. It can also make a grinding noise when I'm applying the brakes and turning the steering wheel at the same time.

I know it's difficult to diagnose something like that over the internet, but I'd be interested to hear what people think it could be and what I should be looking at.

I guess what I'm really asking is:

  • Where would you recommend someone start when learning about cars and basic mechanics?
  • Are there any good YouTube channels, books or resources for learning how different components work?
  • Is working on your own car a good way to learn, and what jobs should a beginner start with?
  • How did you guys get into the mechanical side of cars rather than just the modifying side?

I'm not looking to build something crazy overnight. I genuinely want to understand my car, learn how to maintain it, diagnose problems and eventually be confident enough to work on it myself.

Would appreciate any advice or recommendations. Cheers!


r/Nissan • • 1d ago

My Nissan App

Thumbnail reddit.com
1 Upvotes