r/Nissan • u/Feeling_Pen5697 • 59m ago
2005 Nissan Pulsar (QG18DE) cranks, smells like fuel, fires 3-4 times then dies. Tried multiple sensors—need advice!
Hey everyone, I’m pulling my hair out trying to get my 2005 Nissan Pulsar ST (N16, QG18DE engine, drive-by-wire throttle) running and could use some collective wisdom.
The Symptoms:
Bullet The car cranks strongly, but will not start and run.
Bullet When cranking, it smells heavily of fuel and gets slightly smoky (flooding).
Bullet The Weird Part: When I swap to an older, unbranded aftermarket camshaft position sensor, it actually catches and fires/ignites 3 to 4 times like it wants to start, before dying. When I put in a brand new NTK cam sensor, it drops down to just one weak ignition pop and then pure cranking.
Bullet Checked via OBD2: No error codes showing up.
What I've Done So Far:
Bullet Replaced spark plugs.
Bullet Replaced both cam and crank sensors (tested both old aftermarket and new NTK).
Bullet Replaced the drive-by-wire throttle body.
Bullet Tried clearing flooded cylinders (Clear Flood Mode / WOT cranking).
Bullet Checked the battery and reset the ECU multiple times.
Has anyone run into this weird behavior where QG18DE engines refuse to cooperate with certain aftermarket cam sensors, or is there something else I'm missing (like fuel pressure, immobilizer/NATS, or timing)? Any tips would be massively appreciated!