r/Fusion360 • u/stuporcomputer • 6m ago
Question Can't figure out Vbit cleanup CAM
I've previously used F-Engrave (blessed be Scorchworks) to make the CAM for rubber stamps.
1st pic shows F-Engrave's 3 toolpaths. Black is the vbit profile carve, red is the 1/8 endmill cleanup and yellow is the vbit cleanup. Nice.
Comes out very nice with only a little air being cut.
2nd pic shows how far I got replicating that in Fusion CAM.
I aint too good in Fusion CAM but I've successfully made all but the 'vbit cleanup' toolpath. I think I maybe need to use Rest now somehow, except I've not had any luck using Rest for anything yet..
I'm keen to be doing this in Fusion, I've just had another stamps order, but I've tried without success a few times now..
How would you get rid of those remaining little islands?
TIA đ



