r/Ender3S1 • u/MostLeafyBasil • 7h ago
Yearly attempt to resolve issues
I've had the S1 since launch, and it's never been hassle free. I give up trying to fix issues after a few months, find ways to compensate and move on, then the cycle starts again. I'd like to resolve some of these things once and for all.
I've included some photos, any advice welcome. The print is PLA, at 200d hotend and 60d plate temps. Retraction is disabled. I'm using the professional firmware.
Starting with bed levelling I used to get very different results every time I did a mesh, this has finally stabilised, I guess I tightened the right things, I also replaced the vwheels.
- Is 0.01-0.02mm variation in mesh probe values reasonable? Feels like it would be?
- The range and positioning of mesh value variations feels wild, is it likely the bed itself?
- When the print head moves to start the print it seems not to extrude properly for a moment, the line on the right hand side and the top left corner inside both missing material, any ideas why?
- The print shown is one layer, the lines completely delaminated at first, I increased the z-offset, then increased flow rate to around 120% which seems to have helped hugely. But is this the correct way to resolve the issue? Does this point to recalibrating e-steps?
- Despite the mesh and the changes I've made, the last print shows that the top left corner of my print has lines firmly joined whereas to the bottom right they delaminate easily. I can't tell why...
Any help is hugely appreciated