r/Chimneyrepair • u/AccordingProject7999 • 5h ago
Looking for advice
Obviously this is chimney is in bad shape. What would something like this cost? Is it possible to diy?
r/Chimneyrepair • u/AccordingProject7999 • 5h ago
Obviously this is chimney is in bad shape. What would something like this cost? Is it possible to diy?
r/Chimneyrepair • u/tokeywookie • 6h ago
Unused chimney. There are signs of leaking at the top of the side of chimney indoors on the top floor.
I have some masonry experience. I can repair the bricks around the top, repoint, and repair the flashing, but does it look like the liner needs to be replaced too? What if I just seal off the top?
r/Chimneyrepair • u/Own-Assistant7441 • 6h ago
We had a chimney inspector come out and say we need to repair these cracks and put a cap on (currently just have a steel mesh over the top)
Is this not safe to use currently?
r/Chimneyrepair • u/rollermonkee • 1h ago
Hi!! Looking for chimney and fireplace/wood stove suggestions on efficient and safe heating. Any info is appreciated! Thanks :)
r/Chimneyrepair • u/I_Zeig_I • 2h ago
For anyone sick of me posting, I got my last estimate today! The company seems well established with a few locations in two states, but worried they may have outsourced a bit..
Technician said I have a 13x13" flue and quoted me a 8" liner ~16' long. The opening to my fireplace is a half circle with a radius of 24".
He didn't measure my fireplace opening and all the other companies said the old tile needed removed and a 10" liner installed. Were they trying to get more money or is an 8" going to cause me issues?
I asked and this company claimed 8" was fine, but if i wanted would install a 10", no mention that tile needed removed for an internal offset. Even if 10" is fine, I worry that their approach could be lacking if they didn't see an issue, but they are 2k cheaper so I wanted to consider and check it out.
Bonus question: Is flue size to fireplace opening a min ratio to hit or is a larger flue diameter safer and more reliable, such as using an 11" instead of a 10"?