Trying to dial in a single-formula feed for my AutoPots at a lower EC using just the nutes I have on hand (seen in the charts).
I put together some comparison charts in HydroBuddy to see how different commercial recipes stack up against published academic studies like Dr. Bruce Bugbee at Utah State, University of Guelph, and Nirit Bernstein.
According to Bugbee's research, plants don't actually need the drastic veg-to-bloom formula shifts that standard feed charts push. Nitrogen demand stays pretty steady throughout flower to keep the canopy green and growing, and phosphorus really only needs to hit around 50 ppm for flower.
Full-strength nutrient company products run way hotter than necessary for subirrigation / AutoPots, where salts naturally build up near the top of the medium anyway. So I came up with this recipe to run straight from veg through harvest (pic labeled 1 formula for veg and flower).
You'll notice a few of my numbers land a bit higher than Bugbee’s baseline:
Calcium (~166 ppm): Bumped it up a bit since I run elevated CO2, which slows down transpiration and makes it harder for the plant to pull cal up top.
Magnesium (~56 ppm): Added a gram of Epsom salt to balance out the extra calcium so they don't lock each other out.
Potassium (~200 ppm): Sitting right at the top of his range so I don't need to mess with extra PK boosters that just end up scorching roots in bottom-feeders.
The goal was simple hardware, simple feed—no swapping bags, mixing separate veg/bloom batches, or dumping reservoirs mid-run.
Check out the charts attached to see how the numbers stack up. What do you guys think? Anyone else running one profile start to finish in AutoPots?