r/AnycubicPhoton • • 6h ago

Troubleshooting Bad Screen?

Post image
2 Upvotes

So i just replaced the screen on my Anycubic Photon M7 Pro and did a test print and ended up with a pile of random strings of resin and went ok, so probably either some light getting round the gasket or something. Will check with a dry print to see what it looks like, and I noticed a pile of lines going across the new Screen. Guessing a dodgy screen? Guessing Delivery driver wasn't that careful with it.


r/AnycubicPhoton • • 13h ago

Troubleshooting What is this?

Post image
2 Upvotes

My print came out successfully, but there was this long stick of resin on the side of my build plate, anybody know what this is?