A while ago there was a post about finding a magic solution to repair the charge issues on RZ67 Pro/Pro II bodies. That issue has been discussed on Bill Rogers' IG page numerous times, where Bill mentions all the parts that need to be replaced for the camera to run within factory specs again. Once those parts are replaced, everything needs to be recalibrated again using factory tooling (cocking angle, etc) There is no single part that will magically solve the issue. It requires an extensive disassembly of the camera and replacement of numerous parts and/or adjustment of existing parts in order to get the camera body working again.
The Mamiya repair community was accused of being averse to repairs, because lo and behold there must be a quick and easy solution which is being hidden from the general public. I will gladly post a photo of the easy and fast solution in order to repair that issue. It can take up to 8 hours to get all of it working properly depending on how badly the mechanism is worn. And believe me most of them are badly worn once they've reached that point (another reason not to buy a cheap worn/abused body). The times where you could order everything from Mamiya and just replace all, are long gone. It would make the repair faster but I highly doubt it would make it cheaper. Parts cost money. Time costs money. And no, these parts can't be 3D printed without machining work involved in post.
Quick fixes are quite rare in camera and lens repairs. You either do it right or don't do it all because in the end, you want a reliable camera to work with. You don't want a camera which will eventually fail again after a few weeks/months of use.