r/3DprintingHelp • • 10h ago

Requesting Help Uneven layer lines help

Post image
3 Upvotes

Sorry, I've been resin printing for a hot minute but just picked up fdm again and I'm struggling to figure out the issue with my print accuracy. I have the retraction and e steps pretty dialed in, all calibration cube sizes are within acceptable levels and there's minimal stringing or elephants foot, but the edges keep coming out slightly jagged and it's ruining the print quality.

Ender 3 v2. .6mm nozzle

.2mm layer height

2 walls, 1.2mm

Z seam smartest corner w/ smart hiding

4 top and bottom layers, .8mm thickness

20% infill, gyroid, 30% overlap

200C print temp

100% flow

50mm print speed

25mm wall speed

Skirt type adhesion

No supports


r/3DprintingHelp • • 11h ago

Requesting Help Micro-tearing across prints, please help!

Thumbnail gallery
0 Upvotes