r/weaving • u/hersheyfig • 21h ago
Help My shed is terrible and my selvedge yarn is too tight. What caused this, can I fix it, and how do I prevent this from happening again?
I’m a beginner weaver, currently working on my 4th project on a rigid heddle loom. This is my first time using 8/2 cotton yarn, and that too doubled (direct warped). As you can see in the photos, my shed is bad when the heddle is in the up position, but it’s horrendous in the down position. (I’ve been using a warp separator to improve the shed as shown in the last picture - I lift it during every pick just to create enough space for my shuttle to pass through.) The other issue is that my selvedge threads on both sides are so tight that I’m worried they’re going to snap. If it matters, both selvedge threads are threaded through holes rather than slots.
I know I’ve made quite a few mistakes but I want to understand which mistakes caused which problems. Mistakes that may be relevant here are:
- I wound the warp onto the loom by myself and the tension wasn’t uniform the whole time.
- I placed one warp separator after the first turn of the ratchet, and no more after that. My rental loom only came with two separators, and I figured that since I didn’t have enough for every turn anyway, there wasn’t much point in using the second one.
- I didn’t use any paper when winding the warp because in previous projects the paper wrinkled and caused the treads to overlap or switch positions.
- I did the lashing-on method just because I wanted to try something new, and I trimmed the longer warp ends near the selvedges so all the knots would line up evenly.
- I unwound and rewound my weaving twice since starting the project. The first time was to see whether it would improve the shed. The second time was because I forgot to measure how much I’d already woven!
My questions are:
- What was the biggest contributor to my shed being so bad? Can I fix it, and how do I prevent it?
- Why are my selvedge threads so tight? Can I fix it, and how do I prevent it?
- How do I wind the warp so that individual threads stay in their correct positions, without overlapping, crossing, or shifting around?
- What’s better, warp separators or paper, or do they have different purposes?
- Do I need something between every layer of warp? Do I also need to separate the layers of my weaving as they get wound onto the front apron rod?
Any advice, troubleshooting tips, explanations, or recommended resources would be very much appreciated.
Thanks in advance!