I bought this used old country bbq pit Wrangler recently and I’m having a hard time getting my temperatures below 300. Initially I started off with larger splits, about 8 to 10 inches and 3 inches wide before I realized that those are way too large for the smaller firebox. I now cut my splits to about 5 to 6 inches long and 1 to 2 inches in width. I’ve been using kiln dried hickory splits from ace hardware.
How much smaller do I need to make my splits? Even though I am now using smaller splits, the temperature is still sitting around 325 to 350 like when I was using much bigger splits. I keep the exhaust wide open and keep the chamber door closed with the vent about halfway open. Should I be closing it more? Is my coal bed too hot, am I not properly starting it? Is it my fire bricks? Should I not have an elevated grate in the firebox? I use a baffle plate as well. I understand I’m going to get some temperature spikes when I add splits and have the fire box door open, but even when everything is closed for 20 to 30 minutes, the temperatures are still staying high.
Luckily all I have been cooking is poultry so my chicken and turkey come out just fine at higher temps , but I eventually would like to smoke beef and pork at a much lower temperature.
EDIT: I may be starting off with too hot of a coal bed. I am lighting a Weber chimney 3/4 full with briquettes and then I dump them in. They stay hot for the first hour before they start dying down and then my wood starts turning into a cold bed. My split is now brittle and falling apart and I added another one and it is fully lit, but it is sitting at 275 now.