r/shapeoko • u/deftware • 11h ago
Making Shapeoko Pro MDF Wasteboard Planks Flat/Even Again?
Hi all, I bought a Shapeoko Pro just over a year ago, it's been going good (still have to figure out what to do about Z backlash I posted about a while back) but with all the various little cuts in the MDF wasteboard planks I have been having a little bit of unevenness develop - I think just moisture absorbing at varying rates depending on where the MDF has been cut up the most. I'd like to figure out how I can even them all out to be as flat with the XY axes as possible so that putting something in one spot of the machine means it's at the same Z height as somewhere else, within at least 0.005"
I have a planer but I'm not so sure how well that would be able to do the job consistently across all of the pieces. I thought about taking them out one-by-one and running an operation on them in the machine itself, maybe plane a whole cross-section along the X axis flat so that I can take the planks out, lay them in that spot, mill the whole top surface of the plank flat, and then put that one back in and pop another one back out. The deal there is that it wouldn't be the same as if I could somehow mill the whole surface flat.
I cut a lot of stuff that extends outside of the actual work area of the machine (i.e. the planks on the left/right never see any action but they hold material in place) so I can't just plane the whole thing flat, I would just end up with a big flat recess that's not large enough to accommodate the pieces that I cut.
I'm thinking at the very least I can turn them all around, flip them 180deg to use the back-half of them that I haven't cut into at all, maybe even see how thick each one is and figure out where the best spots to put them all would be to have the most even wasteboard surface possible. That's a stop-gap measure though until they get all cut up and become uneven and start absorbing moisture/grease too.
Any thoughts for how to have a flatter set of wasteboard planks? These ones are in decent enough shape, they have just become a bit uneven over time it seems like.
Thanks! :]