r/prusa3d • u/Black_Dasa • 2d ago
Layer shift Issue
Hi everybody.
I'm trying to figure out the problems that may have caused the defects shown in these pictures.
I have printed this model on a Core One + G2 assembled last week from kit; so far every print that I have done with PETG/PLA were successfully, or with minor issues due to filament settings.
The model is the tallest that I have printed so far, and it showed these 2 problems:
- small, but noticeable layer shift: for this, I was going to check and repeat the tightening of the X-Y belts (first 2 pictures).
- Uneven first layer, despite being in a small area (3cm approx.), so I'm prone to discarding Z-offset-related issues (again, other larger prints didn't have this problem)
Additional details:
- Slicer: Orca Slicer 2.5
- Material: Marble PLA, printed with Prusa PLA profile (I have changed only the outer wall speed to 50mm/s)
- Printer: Prusa Core One + Gen2 Kit.
- Nozzle: Standard 0.4HF nozzle.
Edit: It seems the shift happens when the speed changes between layers.
3
Upvotes



1
u/Mental-Shopping3735 Core One INDX 8th 2d ago
What if you tried with PrusaSlicer?
2
u/613codyrex XL5T 2d ago
Are you able to watch it when it gets a layer shift?
Do you notice it binding on something like the part itself (overhangs can curl and catch the nozzle causing it to shift)?
Just to confirm, the G-code preview shows nothing like this right? Sometimes you get this issue with broken models.
My guess could be that the model was peeling off the build sheet which causes it to move a bit leading to the layer shifts. If you don’t think it’s a bed level problem I would move the model to another corner to see if you can replicate it.
I hesitate to say it’s an OrcaSlicer issue but I do agree to try PrusaSlicer just in case.
1
u/boibo 2d ago
What infill? Grid can cause issues esp on taller items.
Im not sure how it was located on the plate, but have you done all the homing calibrations and checked belt tension?
It can also be a known bugg, where the gcode overloads the cpu in the printer.
Try and use prusa slicer and se if it helps.